50 MHz guard band, that's what I was after :)
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Mar 2, 2017 at 10:14 AM, Jeremy <jeremysmi...@gmail.com> wrote: > I have them at 10MHz channel width. One is at 2412 and one is at 2462. I > usually always do them like that unless there is localized interference on > one of those channels. > > On Thu, Mar 2, 2017 at 8:09 AM, Josh Luthman <j...@imaginenetworksllc.com> > wrote: > >> Jeremy, how much of a guard band was used on this? 20 MHz? 40 MHz? >> >> >> Josh Luthman >> Office: 937-552-2340 <(937)%20552-2340> >> Direct: 937-552-2343 <(937)%20552-2343> >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Wed, Mar 1, 2017 at 8:47 PM, Jeremy <jeremysmi...@gmail.com> wrote: >> >>> I have done this with Ubiquiti on 10Mhz channels without issue. We also >>> have a site with them back to back on 20MHz channels at both ends without >>> issue. They have 4-5' of horizontal separation shooting the same direction >>> and 2-3' back to back. >>> >>> On Wed, Mar 1, 2017 at 6:37 PM, Brandon Yuchasz <li...@gogebicrange.net> >>> wrote: >>> >>>> So we have a site where all of the customers are south of the tower and >>>> we have a 2.4 120 degree KP Performance antenna and ePMP AP pointing at >>>> those customers. We have put a lot of SMs onto the AP and before it gets to >>>> congested we wanted to add an additional AP. It turns out most of the >>>> customers are covered by a 90 degree sector so we put up a second 90 degree >>>> sector( again KP ) on 2.4. I think where we screwed up is we installed >>>> this new sector with 3 feet of horizontal separating from the other sector >>>> and no vertical separation. ( they are side by side pointed in the same >>>> direction) >>>> >>>> >>>> >>>> When we fired it up the SMs on the other AP started to re reg. I have >>>> placed one of the APs at the top of the band on 20 mhz and the other on the >>>> bottom on 20 mhz. Its better but they still drop and register over and >>>> over. >>>> >>>> >>>> >>>> >>>> >>>> So my question is. Has anyone put two 2.4 sectors on the same tower >>>> pointing the same direction successfully? How much vertical separation did >>>> you use? I am assuming vertical is going to be better than what I did. >>>> >>>> >>>> >>>> How much of a guard band did you use? >>>> >>>> >>>> >>>> The 120 degree sector is older so it doesn’t have the same shielding on >>>> top and bottom as the newer 90 degree KP sector. Just FYI. >>>> >>>> >>>> >>>> Thanks, >>>> >>>> Brandon >>>> >>>> >>>> >>>> >>>> >>>> >>>> >>>> >>>> >>> >>> >> >