Lotsa noise sources can.  Should not be any transmitters but there are always 
intermodulation products.  

From: Adam Moffett 
Sent: Thursday, August 24, 2017 12:39 PM
To: [email protected] 
Subject: Re: [AFMUG] ePMP GPS antenna fails

If they just need a power cycle like George is saying then yeah I guess it 
could be.

I think GPS is 1.5ghz and 1.2ghz.  What would interfere with it?


------ Original Message ------
From: [email protected]
To: [email protected]
Sent: 8/24/2017 2:12:21 PM
Subject: Re: [AFMUG] ePMP GPS antenna fails

  Local interference?

  From: Adam Moffett 
  Sent: Thursday, August 24, 2017 12:03 PM
  To: [email protected] 
  Subject: Re: [AFMUG] ePMP GPS antenna fails

  What we're seeing is GPS Status "Down".  We can get it to go "Up" by swapping 
the GPS antenna without rebooting.  If I put the bad antenna back on while it's 
still running I'll still have status "Up", but on a power cycle it goes down 
again.   The problem does follow the antenna.

  That's the one I have in hand.  The other two "fails" could have needed a 
power cycle like you're saying....I guess we'll find out.



  ------ Original Message ------
  From: "George Skorup" <[email protected]>
  To: [email protected]
  Sent: 8/24/2017 1:26:49 PM
  Subject: Re: [AFMUG] ePMP GPS antenna fails

    The ePMP GPS is just like the old 450AP's on-board GPS. You don't 
necessarily need the external antenna. The GTop receivers have a built-in 
antenna. Obviously the problem is they're facing at the horizon and tower 
steel, etc. I have several 1k GPS for PTP links. I didn't need the GPS, just 
the gigabit ethernet. They do not have the pucks attached. They're on Rocket 
dishes facing into a mast and tower steel. Most of them are tracking 14+ out of 
20+ sats. I've said several times before, the newer GTop GPS+GLONASS receivers 
just work better.

    If the radio is seeing no data, then the receiver is probably locked up and 
you'll have to power cycle it. If you're seeing 0 tracked and maybe 0 or a few 
available sats, then the receiver is confused, or it's seeing lots of multipath 
or possibly noise. You can try a power-cycle first, and if that doesn't do 
anything, then try moving the puck. If it's in the top of the Cambium OEM 
antenna, then I guess you're kinda screwed for moving it.

    Easiest solution: SyncInjector/PowerInjector+Sync and a 'Pipe or 'Box.


    On 8/24/2017 11:49 AM, Adam Moffett wrote:

      How often do ePMP GPS antennas fail?


      We had 3 fail in the past month, so I was wondering if they have an 
expected lifespan of some sort.


Reply via email to