you should work directly with packetflux to get this going on the bench, replicate everything you can (cable length, ground, etc). Cambium is not going to be as malleable
On Fri, Jan 5, 2018 at 2:37 PM, Craig Schmaderer <cr...@skywaveconnect.com> wrote: > Andreas, I am doing the same thing. I really like Forrest Rack injector, > so I might hold off on that to power and sync it, but I am definitely going > to run fiber into it. I am looking at options to do this, and was > wondering if you came up with a good idea or tap system that you think will > work to run fiber into the sfp ports? I might splice a 12 strand loose > tune on the ground in a breakout box and then use rugged patch cords to the > radio on top? I would like to use a tap system but I haven’t found one yet > that has a duplex lc jumper? > > > > Thanks, Criag. > > > > *Craig R. Schmaderer* > > *CEO | Skywave Wireless, Inc.* > > *Ph: 402-372-1975 <(402)%20372-1975> | Fax: 402-372-1058 > <(402)%20372-1058>* > > *Direct: 402-372-1052 <(402)%20372-1052>* > > > > > > > > *From:* Af [mailto:af-boun...@afmug.com] *On Behalf Of *Forrest Christian > (List Account) > *Sent:* Sunday, December 31, 2017 2:38 AM > *To:* af <af@afmug.com> > > *Subject:* Re: [AFMUG] 450M maximum length of Cat5e (Just for power) > > > > You can also power a medusa with any PacketFlux PowerInjector+Sync, forgot > to mention this. Power+Ethernet, but not sync (the 450m doesn't support > old-style canopy sync). > > > > Shouldn't be a problem at that length for power, not so much ethernet (but > use a 56V power supply). And a lot cheaper than a CMM5. > > > > On Sat, Dec 30, 2017 at 9:06 PM, David M <dmilho...@wletc.com> wrote: > > here is the link on cambiums site > > according to this it has 1.8A per channel/port > > https://3fdumf3rqw5xx4mjgywguwz9-wpengine.netdna-ssl.com/wp- > content/uploads/2017/09/SS_CMM5_022117v1.pdf > > so I dont see an issue with running all 4 ports with medusa for power .. > .add the controller and now u can turn those ports on and off remotely. > > > > > > On 12/29/2017 10:43 AM, Andreas Wiatowski wrote: > > We need power and timing, but no data… hence the CMM5. > > > > Cheers, > > > > Andreas Wiatowski, CEO > > Silo Wireless Inc. > > 1-866-727-4138 x-600 <(866)%20727-4138> > > http://www.silowireless.com > > Wireless | Fibre | VoIP | PBX | IPTV > > > > Silo Wireless is a Proud Member of: > > CanWISP http://www.canwisp.ca > > WISPA http://wispa.org > > Brantford Brant Chamber of Commerce > > Paris Chamber of Commerce > > Cambridge Chamber of Commerce > > > > > > _________________________________ > > The contents of this email message and any attachments are intended solely > for the addressee(s) and may contain confidential and/or privileged > information and may be legally protected from disclosure. If you are not > the intended recipient of this message or their agent, or if this message > has been addressed to you in error, please immediately alert the sender by > reply email and then delete this message and any attachments. If you are > not the intended recipient, you are hereby notified that any use, > dissemination, copying, or storage of this message or its attachments is > strictly prohibited. > > > > > > *From: *Af <af-boun...@afmug.com> <af-boun...@afmug.com> on behalf of > "ch...@wbmfg.com" <ch...@wbmfg.com> <ch...@wbmfg.com> <ch...@wbmfg.com> > *Reply-To: *"af@afmug.com" <af@afmug.com> <af@afmug.com> <af@afmug.com> > *Date: *Friday, December 29, 2017 at 11:06 AM > *To: *"af@afmug.com" <af@afmug.com> <af@afmug.com> <af@afmug.com> > *Subject: *Re: [AFMUG] 450M maximum length of Cat5e (Just for power) > > > > I would work out ohms law on it to make sure. > > Do you need to run data over the CAT 5? > > If not, you really don’t need the CMM5, just connect all the wires of > similar polarity and connect direct to the power supply. > > > > *From:* Andreas Wiatowski > > *Sent:* Friday, December 29, 2017 7:14 AM > > *To:* af@afmug.com > > *Subject:* [AFMUG] 450M maximum length of Cat5e (Just for power) > > > > Good Morning, > > > > We have a couple of large towers where we will be installing 450M with > fibre. To power we, would like to use the CMM5 , but we are unsure if we > can power the M sufficiently over such a long CAT 5 run. Does anyone have > the answer to this? We could see cat5 runs (Shielded and gell filled) of > upto 500ft! > > > > Cheers, > > > > Andreas Wiatowski, CEO > > Silo Wireless Inc. > > 1-866-727-4138 <(866)%20727-4138> x-600 > > http://www.silowireless.com > > Wireless | Fibre | VoIP | PBX | IPTV > > > > Silo Wireless is a Proud Member of: > > CanWISP http://www.canwisp.ca > > WISPA http://wispa.org > > Brantford Brant Chamber of Commerce > > Paris Chamber of Commerce > > Cambridge Chamber of Commerce > > > > > > _________________________________ > > The contents of this email message and any attachments are intended solely > for the addressee(s) and may contain confidential and/or privileged > information and may be legally protected from disclosure. If you are not > the intended recipient of this message or their agent, or if this message > has been addressed to you in error, please immediately alert the sender by > reply email and then delete this message and any attachments. If you are > not the intended recipient, you are hereby notified that any use, > dissemination, copying, or storage of this message or its attachments is > strictly prohibited. > > > > > > > > > > -- > > *Forrest Christian* *CEO, PacketFlux Technologies, Inc.* > > Tel: 406-449-3345 <(406)%20449-3345> | Address: 3577 Countryside Road, > Helena, MT 59602 > <https://maps.google.com/?q=3577+Countryside+Road,+Helena,+MT+59602&entry=gmail&source=g> > > forre...@imach.com | http://www.packetflux.com > > <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> > <http://twitter.com/@packetflux> > >
