There is nothing wrong with them, just feel a bit loose in the cage. From: Mathew Howard Sent: Monday, May 07, 2018 10:16 AM To: af Subject: Re: [AFMUG] APC surge cards board size
I had some of those too... I got them from Streakwave, around March, I think (although it's possible those were ones I had sitting here for awhile, and I got different ones then... I don't know for certain). On Mon, May 7, 2018 at 11:12 AM, Chuck McCown <ch...@wbmfg.com> wrote: Odd, we have not made those thin cards since last summer and only for a very short lived REV. The jacks were so tall that even with the thin cards and removing some of the jack shield there was still a danger of touching the adjacent card. So we went back to the older jacks. Wonder who you got them from as that is pretty old stock. I will replace them if you want. From: Josh Luthman Sent: Monday, May 07, 2018 10:05 AM To: af@afmug.com Subject: [AFMUG] APC surge cards board size Did anyone else notice the newest cards are much thinner than the new ones? They slide in/out of the WBMFG APC case a whole lot easier. We did check a couple to make sure we had continuity from the shield to ground, so at least it's making connection still. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373