Good afternoon, I purchased an ASRock 939Dual-Sata2 motherboard and I've been trying to enable to onboard audio for several days with no success. I've tried clean installs of 64-bit versions of Debian Sarge (kernels 2.6.12 and 2.6.15.4) and Fedora Core 4 (after applying all updates). The audio device is reported as:
00:08.0 Multimedia audio controller: ALi Corporation M5455 PCI AC-Link Controller Audio Device (rev 20) >From what I can tell, the intel8x0 driver is indicated for this device. >Checking /var/log/messages following boot I see the following audio-related >comments: Feb 19 18:01:06 localhost kernel: ACPI: PCI Interrupt 0000:00:08.0[A] -> GSI 18 (level, low) -> IRQ 225 Feb 19 18:01:06 localhost kernel: AC'97 1 does not respond - RESET Feb 19 18:01:06 localhost kernel: AC'97 1 access is not valid [0xffffffff], removing mixer. Feb 19 18:01:06 localhost kernel: Unable to initialize codec #1 Feb 19 18:01:06 localhost kernel: intel8x0_measure_ac97_clock: measured 54915 usecs Feb 19 18:01:06 localhost kernel: intel8x0: clocking to 48000 Should lines 2--4 make me worry? In Debian, I tried alsa versions 1.0.8 and 1.0.10. In FC4, I used alsa 1.0.10. I've attached to this message the log generated from system-config-soundcard run in FC4 for the sake of completeness. Does anyone have any insight? Until next time, Colin. On Mon, 20 Feb 2006 09:06:02 -0800 [EMAIL PROTECTED] wrote: > Welcome to the [email protected] mailing list! > > To post to this list, send your email to: > > [email protected] > > General information about the mailing list is at: > > https://lists.sourceforge.net/lists/listinfo/alsa-user > > If you ever want to unsubscribe or change your options (eg, switch to > or from digest mode, change your password, etc.), visit your > subscription page at: > > https://lists.sourceforge.net/lists/options/alsa-user/calie%40uwaterloo.ca > > > You can also make such adjustments via email by sending a message to: > > [EMAIL PROTECTED] > > with the word `help' in the subject or body (don't include the > quotes), and you will get back a message with instructions. > > You must know your password to change your options (including changing > the password, itself) or to unsubscribe. It is: > > hiabev > > If you forget your password, don't worry, you will receive a monthly > reminder telling you what all your lists.sourceforge.net mailing list > passwords are, and how to unsubscribe or change your options. There > is also a button on your options page that will email your current > password to you. > > You may also have your password mailed to you automatically off of the > Web page noted above. -- Colin Alie BSc, MASc PhD Candidate Department of Chemical Engineering University of Waterlo Waterloo, Ontario N2L 3G1 [EMAIL PROTECTED]
scsound.log
Description: Binary data
