Gunnar,
amanda can do automatic vault to the defined 'vault-storage' (during the
amdump run), for that, you need to put a 'vault' in the source storage.
Remove the vault-storage setting if you do not want this feature, and
you run to run amvault manually.
Jean-Louis
On 19/09/17 04:02 PM, Gunnarsson, Gunnar wrote:
>
> Hello amanda-users,
>
> When I upgraded to amanda version 3.4.5 I added a storage section in
> order to run the amvault and it works. But the daily runs are
> complaining about not finding any volumes in that storage sections as
> they are marked no-reuse. So what is wrong with my setup ?
>
> when I’m getting the error below after each daily runs.
>
> These dumps were to tapes Orabck-Unix-006, Orabck-Unix-007.
>
> *** A TAPE ERROR OCCURRED: [No acceptable volumes found].
>
> Some dumps may have been left in the holding disk.
>
> The next 3 tapes Amanda expects to use are: Orabck-Unix-008,
> Orabck-Unix-009, Orabck-Unix-010.
>
> vault-storage "vault-st"
>
> #
>
> # define storage
>
> define storage "vault-st" {
>
> autolabel "Orabck-Unix-2%%" empty
>
> tapetype "HP-Ultrium3"
>
> tpchanger "vault"
>
> }
>
> Thanks Gunnar Gunnarsson
>
This message is the property of CARBONITE, INC. and may contain confidential or
privileged information.
If this message has been delivered to you by mistake, then do not copy or
deliver this message to anyone. Instead, destroy it and notify me by reply
e-mail
