Now that you mention it Don, I remember those Globar resistors your
talking about.
The card that the thermistor I used in the 117Z6 circuit listed it as a
resistor.
It was made by Workman Electronics and clearly stated that it was a
Globar Resistor.
I had it left over from my TV days.
I installed it and tested it. It was about 150 ohms cold. And dropped to
around 6 ohms after a
very short warm up. So it most certainly is better described as a
thermistor. I have no clue as to
why Workman would package it saying "Golbar Resistor", but that's what
they did.
George KE4HJ
Donald Chester wrote:
Don't confuse Globar thermistors with Globar resistors. The latter
are non-inductive power resistors often used in dummy loads and
parasitic suppressors.
My dummy load is made up of a dozen 600 ohm 150 watt Globars. Each
one is about 18" long and 1" in diameter. Supposedly you can heat
them to a dull red glow without hurting them, but I have never tried
running that much power, and I'm not sure what such abuse would do to
the resistance. I have heard of the ones used in parasitic
suppressors of high power BC transmitters (50 kw) glowing under
parasitic conditions.
Don
______________________________________________________________
AMRadio mailing list
Home: http://mailman.qth.net/mailman/listinfo/amradio
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:AMRadio@mailman.qth.net