Hi, Even when I listen to QSO's on 80m and 40m?
I'm suspecting of Driver and Finals, because the set was obviously overcharged (wire replacing the fuse, transformer and PCB completely burned!) and perhaps desaligned for 11m... Since the 6KD6's are original (Toshiba with green band) and seem to be expensive... I would like to know if there is some expedite test to check their performance? I think that the display is not working properly, since on some band selection the first digits are overlapping (28 and 29, 14 nd 21) and some are not showing (3.5 and 7). Could it be some degradation at old IC's and transistors or diodes? What should be tested first here in the counter? Where could we find the service manual? Many thanks for your attention and *** Best Wishes for 2006 *** 73 de Jose CT1AXG Date: Wed, 28 Dec 2005 23:28:07 -0600 From: "Rev. Don Sanders" <[EMAIL PROTECTED]> Subject: Re: [AMRadio] FT-501: No Tx Output To: Discussion of AM Radio <amradio@mailman.qth.net> Message-ID: <[EMAIL PROTECTED]> Content-Type: text/plain; charset=iso-8859-1 Sounds like one of your mixing oscillators is malfunctioning. Check the frequency of each of your oscillators and the output of your mixers to make sure you have all the needed frequencies. Healthfully yours, DON W4BWS __________________________________ Yahoo! for Good - Make a difference this year. http://brand.yahoo.com/cybergivingweek2005/