Hi, On 04.03.2012 13:48, Gary Thomas wrote:
> All of the recent images I've built (for beaglebone at least) > fail on boot with these messages: > > Starting Journal Service... > Failed to start Journal Service > [FAILED] > See 'systemctl status systemd-journald.service' for details. > Dependency failed. Aborted start of Getty on tty1 > [ ABORT] > Dependency failed. Aborted start of Serial Getty on ttyO0 > [ ABORT] > > Since this is a very early-on failure, nothing runs and I can't get in > to run the status command to figure out what's wrong. Perhaps there is > some way to get more verbose output to the console? I could edit some > config file, etc, offline an try another boot. > > This build was for systemd-image, from a 100% scratch setup, I'm in the same boat except I get access to the serial terminal in the end. I'm new to systemd so I have to read a little bit about it. In the meantime the suggested commands returns : root@ixppci:~# systemctl status systemd-journald.service Failed to get D-Bus connection: No connection to service manager. My image is a modified version of systemd-image that uses a modified version of task-basic which doesn't install the connection manager and avahi. My image had to be smaller than 14MB to fit in a 16MB chip with the Kernel (~2MB). I'll keep you informed if I find anything. Best regards, -- Christophe Aeschlimann Embedded Software Engineer & IT Manager ACN Advanced Communications Networks S.A. 2000 - Neuchâtel, Switzerland Tel. +41 32 724 74 31 _______________________________________________ Angstrom-distro-devel mailing list Angstrom-distro-devel@linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-devel