Thanks a lot !
I'm trying to set this MAC in the boot.scr using :
optargs=ethaddr=11:22:33:44:55:66
but without success at this time
I will look around to see if my kernel has all the related patches
Best Regards,
Chris
Le 30/05/2012 00:49, Gavin Swanson a écrit :
There's a feature that will bump the eth# if it gets a new Mac address.
Check if eth 1 or 2 works
On May 29, 2012 1:50 PM, "chrbruno"<[email protected]> wrote:
Hello (i'm new to Angstrom),
I'm running an image for beagleboad based on the steps at
http://www.angstrom-**distribution.org/building-**angstrom<http://www.angstrom-distribution.org/building-angstrom>
All is running except that the eth0 interface is not automatically up
after boot (smsc95xx)
A manual ifup eth0 do the work
I found messages in the beagleboard list that mentionned the image
Angstrom-Cloud9-IDE-eglibc-**ipk-v2011.12-core-beaglebone-**2011.12.13.img.gz
fixed the issue
but my problem is that I cannot update my SDCard at this time
could someone tell me how to find the patches for this problem ?
Best Regards,
Chris
______________________________**_________________
Angstrom-distro-devel mailing list
Angstrom-distro-devel@**linuxtogo.org<[email protected]>
http://lists.linuxtogo.org/**cgi-bin/mailman/listinfo/**
angstrom-distro-devel<http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-devel>
_______________________________________________
Angstrom-distro-devel mailing list
[email protected]
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-devel
_______________________________________________
Angstrom-distro-devel mailing list
[email protected]
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-devel
