Whenever I load the zaptel drivers (specifically wcfxs) I get the following
message from my system (see full log below):
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0-0x1f at device 20.2
on pci0
uhci0: Could not allocate irq
device_attach: uhci0 attach returned 6
Why my PIIX4 has no IRQ allocated is another story, but I don't understand
why it is being probed at all at this point. I am _not_ using the ztdummy
driver (but in any case I don't think this uses uhci for timing on FreeBSD).
I haven't been able to see any reference to uhci or to usb in the source
either for wcfxs or for zaptel itself.
Any ideas as to why this happens?
--- cut here 8<-------------
almaz# /sbin/kldload /usr/local/lib/zaptel/zaptel.ko
Zapata Telephony Interface Registered on major 196
almaz# /sbin/kldload /usr/local/lib/zaptel/wcfxs.ko
FXS device: vendor=e159 device=1 subvendor=b119
wcfxs0: <Wildcard TDM400P REV I> port 0x2000-0x20ff mem
0xc6cfe000-0xc6cfefff irq 15 at device 15.0 on pci0
FXS Attach for wcfxs0: deviceID : 0xe159
Freshmaker version: 73
Freshmaker passed register test
Module 0: Installed -- AUTO FXS
ProSLIC sanity check failed
Module 1: Not installed
ProSLIC sanity check failed
Module 2: Not installed
Module 3: Installed -- AUTO FXO
Found a Wildcard TDM: Wildcard TDM400P REV I (4 modules)
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0-0x1f at device 20.2
on pci0
uhci0: Could not allocate irq
device_attach: uhci0 attach returned 6
almaz#
--- cut here 8<-------------
--
Thomas Sandford
_______________________________________________
Asterisk-BSD mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-bsd
