Re: [Asterisk-bsd] Kim Culhan's FreeBSD 6.0 STABLE asterisk install notes

Wed, 07 Dec 2005 15:12:48 -0800

Kim -

Kim Culhan wrote:
On 12/4/05, Dean Billing <[EMAIL PROTECTED]> wrote:
  
My question is, since I have installed zaptel and asterisk from PORTS,
should I deinstall them before actually building zaptel and asterisk
from the svn source?
    

Sorry to take so long to reply..

You can de-install by just saying 'make deinstall' in the top level of the
zaptel and asterisk ports.

Doing this will only remove the fies installed by the two ports, leaving
the other port dependencies intact. You need these to compile the
new versions of zaptel and asterisk so this approach works fine.
I appreciate all your insights.  I was able to install Zaptel and it almost worked, at least it quit locking up.  It recognizes the DigitNetworks X100P but says it can't load it and exits with an Error 5.  I have an email in to DigitNetworks but no reply.  I get the feeling from other threads that the PCI hardware interface cards are a bit cantankerous with different PCI implementations on M/Bs.  This installation is on a new Gigabyte GA-8IKHXT server M/B.  Unfortunately the Adaptec SATA RAID controller on this M/B wasn't supported in FreeBSD 5.4 or I would have started there.

I did have one other question or observation.  You had responded to my email about installing zaptel once before:
> Please change the procedure as described in my note from 12-4-05
>
> Compile and install the libpri in the latest zaptel-bsd source obtained via
Subversion.
This made no sense to me since I could not find the libpri sources in the zaptel-bsd source obtained via Subversion?

Regards -- Dean
_______________________________________________
Asterisk-BSD mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-bsd

Reply via email to