That reminds me, Cisco has a new device out, the IAD2430 that has T1
ports VWIC, and FXS ports.  It will proably cost a bundle, though.
Looks like the IAD2432 will handle 24 analog ports, up to two Data T1s
and a voice T1 using the VWIC port.  Supports SIP and MGCP.

        -----Original Message----- 
        From: Michael Kane 
        Sent: Mon 6/30/2003 2:38 PM 
        To: [EMAIL PROTECTED] 
        Cc: 
        Subject: Re: [Asterisk-Users] Minimum budget question ...
        
        

        The Cisco 242x (20 or 21), has a 24 port analog interface that
supports 16
        FXS and 8 FXO.  I've delpoyed hundreds of these IAD's signaling
with MGCP.
        Not sure if it supports SIP yet.  Hope this helps...
        
        Mike
        
        Michael Kane
        To-Talk Communications LLC.
        37 Sandusky Dr.
        Wareham, Ma. 02571
        508-295-2826
        ----- Original Message -----
        From: "Andy Powell" <[EMAIL PROTECTED]>
        To: <[EMAIL PROTECTED]>
        Sent: Monday, June 30, 2003 2:51 PM
        Subject: Re: [Asterisk-Users] Minimum budget question ...
        
        
        > Hi Tan,
        >
        > Thanks for the reply. I'll end up asking a load more questions
now...
        >
        > What sort of prices are we talking about for the 24 port
        > VoIP gateway?
        >
        > I assume that each port is individually addresable by *?
        >
        > As I recall the 24 port gateways tend to be terminated at the
FXS side
        > as some 'wierd' connector (wierd in that it's not rj45/11) do
you just
        > wire this to a patch panel?
        >
        > What codec is in use to get all 24 ports 'running' at the same
time..G729?
        > Does this cause problems since iirc * needs to run in console
mode for
        > the G729 codec to work properly
        >
        > Thanks for the info... interesting site too :D
        >
        > Andy
        >
        >
        >
        > *********** REPLY SEPARATOR  ***********
        >
        > On 30/06/2003 at 19:21 Tan Aks wrote:
        >
        > >Hi,
        > >
        > >We provide asterisk-based solutions to customers based in the
uk. One of
        > >our
        > >customers (9 users) is trialling our low-end solution which
comprises of
        a
        > >box with 2 x X100P (analogue line) cards installed, and a
voip carrier
        for
        > >outgoing calls. This customer intends to have 13 extensions
in his "live"
        > >scenario. The way to use multiple analogue phones is:
        > >
        > >        1) get a T100P card and use a T1 channel bank sourced
from the US
        > >        2) use a couple of TDM400P cards to give 8
extensions, and use IP
        > >phones for the other extensions
        > >        3) use a voip gateway to provide up to 24 x analogue
extensions
        per
        > >IP address. VoIP gateways are commonly available and convert
analogue
        lines
        > >into a SIP/H323 VoIP stream.
        > >
        > >You can get an E1 terminated with an RJ45. If you have a coax
        termination
        > >then you can use a balun to get rj45 connectivity.
        > >
        > >Hope that helps.
        > >Tan (telappliant.com)
        > >
        > >
        > >
        > >
        > >----- Original Message -----
        > >From: "Andy Powell" <[EMAIL PROTECTED]>
        > >To: <[EMAIL PROTECTED]>
        > >Sent: Monday, June 30, 2003 5:26 PM
        > >Subject: RE: [Asterisk-Users] Minimum budget question ...
        > >
        > >
        > >Tim,
        > >
        > >a good comprehensive answer to the question...certainly gave
me a few
        > >things
        > >to think about. I do have a few questions though, since I'm
in Europe.
        > >
        > >Has anyone in Europe set up something equivalent to what Tim
suggested?
        > >
        > >What sort of prices did it work out at?
        > >
        > >How did you solve the channel bank 'issue' in Europe?
        > >
        > >I keep reading that E1 lines are coax terminated, is this
correct or do
        you
        > >usually get a choice from your teleco?
        > >
        > >Were there any other issues to contend with?
        > >
        > >I'd certainly be interested in the experiences of anyone in
Europe...
        > >
        > >Thanks
        > >
        > >Andy
        > >
        > >
        > >
        > >
        > >On 30/06/2003 at 10:55 [EMAIL PROTECTED] wrote:
        > >
        > >>If this is for commercial use, especially if you are going
to be selling
        > >>this solution, I would suggest that you don't even offer the
choice of
        > >>analog lines except in the smallest of offices.  Unless you
like to
        > >>spend a lot of unbillable time supporting them :)
        > >>
        > >
        > >
        > >
        > >_______________________________________________
        > >Asterisk-Users mailing list
        > >[EMAIL PROTECTED]
        > > http://lists.digium.com/mailman/listinfo/asterisk-users
        > >
        > >
        > >_______________________________________________
        > >Asterisk-Users mailing list
        > >[EMAIL PROTECTED]
        > > http://lists.digium.com/mailman/listinfo/asterisk-users
        >
        >
        >
        > _______________________________________________
        > Asterisk-Users mailing list
        > [EMAIL PROTECTED]
        > http://lists.digium.com/mailman/listinfo/asterisk-users
        >
        
        _______________________________________________
        Asterisk-Users mailing list
        [EMAIL PROTECTED]
        http://lists.digium.com/mailman/listinfo/asterisk-users
        

<<winmail.dat>>

Reply via email to