Hey all, I have an Asterisk-box with an E100P and a PRI (Euro-ISDN) coming into it from a Meridian-switch. The incoming numbers on this PRI all start with the same digit and the last part of the dialled number is signalled to Asterisk digit by digit, until Asterisk signals that the number is complete and the call rings.
All works well, unless I have 2 or more numbers which start with the same digits. In that case, dialling will be signalled as complete as soon as the shortest of the numbers is dialed. An example: exten => 31801,1, ... exten => 3180,1, ... In this case, dialling "3180" will immediately start ringing, while on similar setups, with TDM40B's and analog phones, Asterisk will wait for the duration of "digittimeout" for more digits, if it can't be absolutely certain that the dialled number is complete. If I remove the "3180" in the above example, ringing will only start after "31801" is fully dialled. Relevant configs: /etc/zaptel.conf: bchan=1-15 dchan=16 bchan=17-31 /etc/asterisk/zapata.conf: switchtype=euroisdn signalling=pri_cpe immediate=no Any ideas? Grtz, Oliver _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users