Why do you see the problem with that ? How would you use that functionality that analog channels have ?
With PRI you're going to always receive the full number that was dialed. So since you have a limited number of DID's do the matching one for one and it'll work. regards Martin On Wed, 9 Jul 2003, The Traveller wrote: > Hey all, > > I have an Asterisk-box with an E100P and a PRI (Euro-ISDN) coming > into it from a Meridian-switch. The incoming numbers on this PRI all start > with the same digit and the last part of the dialled number is signalled to > Asterisk digit by digit, until Asterisk signals that the number is > complete and the call rings. > > All works well, unless I have 2 or more numbers which start with the same > digits. In that case, dialling will be signalled as complete as soon > as the shortest of the numbers is dialed. An example: > > exten => 31801,1, ... > exten => 3180,1, ... > > In this case, dialling "3180" will immediately start ringing, while > on similar setups, with TDM40B's and analog phones, Asterisk will > wait for the duration of "digittimeout" for more digits, if it can't > be absolutely certain that the dialled number is complete. If I remove > the "3180" in the above example, ringing will only start after "31801" > is fully dialled. > > > Relevant configs: > > /etc/zaptel.conf: > > bchan=1-15 > dchan=16 > bchan=17-31 > > /etc/asterisk/zapata.conf: > > switchtype=euroisdn > signalling=pri_cpe > immediate=no > > > Any ideas? > > > > Grtz, > > Oliver > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users