Put the IP addresses of each phone on the IAX.conf section. Then we can check the rest.
Carlos -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Zoltan Szecsei Sent: Friday, July 08, 2005 10:01 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] IAXphone -> ip address -> extension number. Hi, Sorry - just got back. Here is what you wanted, but I am also concerned about the "unable to open iax timing interface" - scan this email for "timing" to pick it up below. Note the lsmod at the very end of this email, showing that ztdummy is loaded. I tried compiling and loading zaprtc after I sent the previous email, but I could not successfully "make load" it. Thanks for helping, Zoltan. +++++++++++++++++++++++++++++ == RTP Allocating from port range 10000 -> 20000 Asterisk Ready. *CLI> *CLI> iax2 show peers Name/Username Host Mask Port Status z2 (Unspecified) (D) 255.255.255.255 0 Unmonitored z1 (Unspecified) (D) 255.255.255.255 0 Unmonitored *CLI> *CLI> *CLI> stop now Beginning asterisk shutdown.... Executing last minute cleanups == Destroying any remaining musiconhold processes Asterisk cleanly ending (0). gl0:/home/zls # +++++++++++++++++++++++++++++++++++++++++++++++ Carlos Alperin wrote: >Zoltan, > >Ok. I believe that I know what is going on: > >Just for confirm can you go inside the system : run asterisk -r > >Then run IAX2 SHOW PEERS and tell me what you get? > >When you finish you can exit with quit. > >I think that the system doesn't know where are the phones located. > >Thanks, > >Carlos > >-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED] On Behalf Of Zoltan Szecsei >Sent: Friday, July 08, 2005 6:17 AM >To: Asterisk Users Mailing List - Non-Commercial Discussion >Subject: Re: [Asterisk-Users] IAXphone -> ip address -> extension number. > >Carlos Alperin wrote: > > > >>The only reason for try SIP, is to find where the problem is. >> >>You can use what you prefer, if you can made it works. >> >>Any chance to see both SIP & IAX.conf? >> >>Thanks, >> >>Carlos >> >> >> >> >> >Hi Carlos, >Thanks for you help thusfar. >I have provided: > >iax.conf >extensions.conf >bits of log from asterisk -vvvvvvvvvvgc >last bits from making zaptel >modprobe/lsmod ztdummy. > >Note that I have renamed zaptel.conf and sip.conf because I am under the >impression I do not need them. I dont want to add SIP until IAX works, >and I have no special HW, so dont need zaptel.conf. > >Note also at this stage extensions.conf has only what I hope it needs to >just make the other phone ring. > >The SuSE 9.3 box running asterisk 1.0.9 has IP 192.168.0.100 and phones >z1 and z2 have 192.168.0.201 and 202 respectively. > >++++++++++++++++++++++++++++++++++ >gl0:/etc/asterisk # cat iax.conf >[general] >port=4569 >bindaddr=0.0.0.0 >bandwidth=medium >disallow=LPC10 >;deny=all >;all0w=ulaw >;all0w=alaw >;all0w=gsm >jitterbuffer=yes > >; register => zoltan:[EMAIL PROTECTED] > > >[z1] >type=friend >host=dynamic >mailbox=1201 >context=geograph >callerid="Zoltan1" <201> > >[z2] >type=friend >host=dynamic >mailbox=1202 >context=geograph >callerid="Zoltan2" <202> >gl0:/etc/asterisk # > >++++++++++++++++++++++++++++++++++ >gl0:/etc/asterisk # cat extensions.conf >[general] >static=yes >writeprotect=no > >[globals] >CONSOLE=Console/dsp ; Console interface for demo >;CONSOLE=Zap/1 >;CONSOLE=Phone/phone0 >IAXINFO=guest ; IAXtel username/password >;IAXINFO=myuser:mypass >TRUNK=Zap/g2 ; Trunk interface >TRUNKMSD=1 ; MSD digits to strip >(usually 1 or 0) >;TRUNK=IAX2/user:[EMAIL PROTECTED] > >[geograph] >exten=> 201,1,Dial(IAX/z1,20,tr) >exten=> 202,1,Dial(IAX/z2,20,tr) >exten=> 1201,1,Dial(IAX/z1,20,tr) ; not relevant yet >exten=> 1202,1,Dial(IAX/z2,20,tr) ; not relevant yet > >++++++++++++++++++++++++++++++++++ > From asterisk -vvvvvvvvvvvvvvvgc > > >snip===8<===snip===8<===snip===8<===snip=== > > [res_musiconhold.so] => (Music On Hold Resource) > == Parsing '/etc/asterisk/musiconhold.conf': Found >Jul 8 11:58:13 WARNING[32206]: res_musiconhold.c:565 moh_register: >Unable to open pseudo channel for timing... Sound may be choppy. > == Registered application 'MusicOnHold' > == Registered application 'WaitMusicOnHold' > == Registered application 'SetMusicOnHold' > [pbx_config.so] => (Text Extension Configuration) > == Parsing '/etc/asterisk/extensions.conf': Found > -- Setting global variable 'CONSOLE' to 'Console/dsp' > -- Setting global variable 'IAXINFO' to 'guest' > -- Setting global variable 'TRUNK' to 'Zap/g2' > -- Setting global variable 'TRUNKMSD' to '1' > -- Registered extension context 'geograph' > -- Added extension '201' priority 1 to geograph > -- Added extension '202' priority 1 to geograph > -- Added extension '1201' priority 1 to geograph > -- Added extension '1202' priority 1 to geograph > [pbx_spool.so] => (Outgoing Spool Support) > [cdr_csv.so] => (Comma Separated Values CDR Backend) > [cdr_manager.so] => (Asterisk Call Manager CDR Backend) > == Parsing '/etc/asterisk/cdr_manager.conf': Found > [chan_agent.so] => (Agent Proxy Channel) > == Registered channel type 'Agent' (Call Agent Proxy Channel) > == Registered application 'AgentLogin' > == Registered application 'AgentCallbackLogin' > == Registered application 'AgentMonitorOutgoing' > == Parsing '/etc/asterisk/agents.conf': Found > [chan_iax2.so] => (Inter Asterisk eXchange (Ver 2)) >Jul 8 11:58:13 WARNING[32206]: chan_iax2.c:7477 load_module: Unable to >open IAX timing interface: No such file or directory > == Manager registered action IAXpeers > == Parsing '/etc/asterisk/iax.conf': Found > == Registered channel type 'IAX2' (Inter Asterisk eXchange Driver (Ver 2)) > == Using TOS bits 0 > == IAX Ready and Listening on 0.0.0.0 port 4569 > == Loaded firmware 'iaxy.bin' > == Parsing '/etc/asterisk/iaxprov.conf': Found > -- Loaded provisioning template 'default' > [chan_local.so] => (Local Proxy Channel) > == Registered channel type 'Local' (Local Proxy Channel Driver) > > >snip===8<===snip===8<===snip===8<===snip=== > > >[chan_sip.so] => (Session Initiation Protocol (SIP)) > == Parsing '/etc/asterisk/sip.conf': Not found (No such file or directory) >Jul 8 11:58:13 NOTICE[32206]: chan_sip.c:8679 reload_config: Unable to >load config sip.conf, SIP disabled > == Registered channel type 'SIP' (Session Initiation Protocol (SIP)) > == Registered application 'SIPDtmfMode' > [chan_skinny.so]Jul 8 11:58:13 WARNING[32206]: chan_oss.c:257 >sound_thread: Read error on sound device: Resource temporarily unavailable > => (Skinny Client Control Protocol (Skinny)) > == Parsing '/etc/asterisk/skinny.conf': Found >Jul 8 11:58:13 WARNING[32206]: chan_skinny.c:2587 reload_config: Unable >to get our IP address, Skinny disabled > == Registered channel type 'Skinny' (Skinny Client Control Protocol >(Skinny)) > [codec_a_mu.so] => (A-law and Mulaw direct Coder/Decoder) > == Registered translator 'alawtoulaw' from format alaw to ulaw, cost 1 > == Registered translator 'ulawtoalaw' from format ulaw to alaw, cost 1 > > >snip===8<===snip===8<===snip===8<===snip=== > > [app_zapateller.so] => (Block Telemarketers with Special Information Tone) > == Registered application 'Zapateller' > == Parsing '/etc/asterisk/enum.conf': Found > == Parsing '/etc/asterisk/extconfig.conf': Found > == Parsing '/etc/asterisk/logger.conf': Found >Asterisk Event Logger restarted > == Parsing '/etc/asterisk/manager.conf': Found > == Parsing '/etc/asterisk/enum.conf': Found > == Parsing '/etc/asterisk/rtp.conf': Found > == RTP Allocating from port range 10000 -> 20000 >Asterisk Ready. >*CLI> iax2 show users >Username Secret Authen Def.Context >A/C >z2 -no secret- 000000000000003 geograph >No >z1 -no secret- 000000000000003 geograph >No >*CLI> >*CLI> >*CLI> iax2 show peers >Name/Username Host Mask Port Status >z2 (Unspecified) (D) 255.255.255.255 0 Unmonitored >z1 (Unspecified) (D) 255.255.255.255 0 Unmonitored >*CLI> >*CLI> > > >++++++++++++++++++++++++++++++++++ > >/usr/src/zaptel-1.0.9 make clean ; make linux26 ; make install > >snip===8<===snip===8<===snip===8<===snip=== > >install tor2 /sbin/modprobe --ignore-install tor2 && /sbin/ztcfg >install torisa /sbin/modprobe --ignore-install torisa && /sbin/ztcfg >install wcusb /sbin/modprobe --ignore-install wcusb && /sbin/ztcfg >install wcfxo /sbin/modprobe --ignore-install wcfxo && /sbin/ztcfg >install wcfxs /sbin/modprobe --ignore-install wcfxs && /sbin/ztcfg >install ztdynamic /sbin/modprobe --ignore-install ztdynamic && /sbin/ztcfg >install ztd-eth /sbin/modprobe --ignore-install ztd-eth && /sbin/ztcfg >install wct1xxp /sbin/modprobe --ignore-install wct1xxp && /sbin/ztcfg >install wct4xxp /sbin/modprobe --ignore-install wct4xxp && /sbin/ztcfg >install wcte11xp /sbin/modprobe --ignore-install wcte11xp && /sbin/ztcfg >install ztdummy /sbin/modprobe --ignore-install ztdummy && /sbin/ztcfg >if ! grep "alias wctdm" /etc/modprobe.d/zaptel; then \ > echo "alias wctdm wcfxs" >> /etc/modprobe.d/zaptel; \ >fi \ > >alias wctdm wcfxs >if [ -d /etc/modutils ]; then \ > /sbin/update-modules ; \ >fi >[ `id -u` = 0 ] && /sbin/depmod -a || : >[ -f /etc/zaptel.conf ] || install -D -m 644 zaptel.conf.sample >/etc/zaptel.conf >gl0:/usr/src/zaptel-1.0.9 # > > >++++++++++++++++++++++++++++++++++ >from modprobe ztdummy and lsmod | grep z > >gl0:/usr/src/zaptel-1.0.9 # modprobe ztdummy >Notice: Configuration file is /etc/zaptel.conf >line 142: Unable to open master device '/dev/zap/ctl' >gl0:/usr/src/zaptel-1.0.9 # lsmod | grep z >Module Size Used by >ztdummy 7744 0 >zaptel 239620 1 ztdummy >crc_ccitt 6144 1 zaptel >gl0:/usr/src/zaptel-1.0.9 # > >++++++++++++++++++++++++++++++++++ > > >_______________________________________________ >Asterisk-Users mailing list >[email protected] >http://lists.digium.com/mailman/listinfo/asterisk-users >To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > >_______________________________________________ >Asterisk-Users mailing list >[email protected] >http://lists.digium.com/mailman/listinfo/asterisk-users >To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
