Tzafrir Cohen: > On Sat, Jul 22, 2006 at 09:02:48PM +0200, Frank Darner wrote: > > Hi, > > > > I have problem to set up an X100P clone card. > > Installation of zaptel was successful. > > Also modprobe of zaptel, ztdummy and wcfxo without problems. > > > > kernel: wcfxo: module not supported by Novell, setting U taint flag. > > kernel: ACPI: PCI Interrupt 0000:05:04.0[A] -> GSI 16 (level, low) -> IRQ > > 193 kernel: wcfxo: DAA mode is 'FCC' > > kernel: Found a Wildcard FXO: Generic Clone > > kernel: Registered tone zone 0 (United States / North America) > > > > > > But if I do #ztcfg -vvv no channels will be found. >
Hi, OK, I do # modprobe zaptel && modprobe wcfxo > What is the exact output from that command? linux:/proc/zaptel # ztcfg -vvv Zaptel Configuration ====================== Channel map: 0 channels configured. > > What is the output from 'cat /proc/zaptel/*' nothing dir /proc/zaptel but is empty BUT, if I do additional # modprobe ztdummy linux:/proc/zaptel # cat /proc/zaptel/* Span 1: ZTDUMMY/1 "ZTDUMMY/1 1" any ideas ? thanks _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users