Am Sunday 23 July 2006 06:39 schrieb Tzafrir Cohen: > On Sat, Jul 22, 2006 at 09:02:48PM +0200, Frank Darner wrote: > > Hi, > > > > I have problem to set up an X100P clone card. > > Installation of zaptel was successful. > > Also modprobe of zaptel, ztdummy and wcfxo without problems. > > > > kernel: wcfxo: module not supported by Novell, setting U taint flag. > > kernel: ACPI: PCI Interrupt 0000:05:04.0[A] -> GSI 16 (level, low) -> IRQ > > 193 kernel: wcfxo: DAA mode is 'FCC' > > kernel: Found a Wildcard FXO: Generic Clone > > kernel: Registered tone zone 0 (United States / North America) > > > > > > But if I do #ztcfg -vvv no channels will be found. > > What is the exact output from that command? > > What is the output from 'cat /proc/zaptel/*'
After delete of all Asterisk files and complete new install I got something: # modprobe zaptel && modprobe wcfxo linux:/proc/zaptel # cat /proc/zaptel/* Span 1: WCFXO/0 "Generic Clone Board 1" RED 1 WCFXO/0/0 but # ztcfg -vvvv is still no channels. any ideas? _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users