Hi, you can also load the wct4xxp driver with
modprobe wct4xxp t1e1override=1 Does the same job, remotely. Kind regards, Martin List-Petersen On Fri, 2004-08-20 at 22:11, Arnaud Pignard wrote: > Ok, i haven't get in hand the card and make remote hardware install. > > It's certainely the problem. > > Thanks ! > > At 22:49 20/08/2004, you wrote: > >On Fri, 20 Aug 2004, Arnaud Pignard wrote: > > > > > I try setup a TE410P. Already setup E100P without problem. I also check > > > sample zaptel.conf config in mailing list and seems my config is ok. > > > However when i modprobe wct4xxp, here is error output : > > > > > > ZT_CHANCONFIG failed on channel 97: No such device or address (6) > > > FATAL: Error running install command for wct4xxp > > > >Have you configured the spans for E1 signalling? It sound like you have > >them set for T1 signalling (24*4=96). You should check the jumpers on the > >card. > > > >Peter > > > > > >_______________________________________________ > >Asterisk-Users mailing list > >[EMAIL PROTECTED] > >http://lists.digium.com/mailman/listinfo/asterisk-users > >To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users