I posted a while ago, about the FXO card entering a non-operational state. While in a call, all of a sudden, there's this loud noise, and the card remains like that until I reload the wcfxo module. There's no way to dial in or out the FXO unless the module is reloaded.
I made some progress... I was looking for an indication in the system that the problem was occurring. Well, I found it. When the FXO "blows up" asterisk gets the following event: WARNING[213006]: Detected alarm on channel 1: Red Alarm Last night I was talking on the FXO extension, and it happened. Just to confirm, I went to /var/log/asterisk and looked at the messages file. There it was: the freaking Red Alarm. I noticed that the Red Alarm also happens when I unplug the phone line. When I plug it back, there's this notice: NOTICE[229390]: Alarm cleared on channel 1 I'm wondering if it's the FXO that causes the problem, or if it's the line that puts the FXO in the inoperable state. I don't know if it makes any difference, but the line is connected to a PBX, not directly to the telco. So, instead of shutting down asterisk, reloading the module, and starting asterisk again, I will take a look at the drivers source to see if I manage to make it self-restart when it detects the Red Alarm. Any thoughts? Suggestions? Marconi. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users