> I'm having with an echo or delay > > I connect to the PSTN with a x100p and then connect a std. phone > to a FXS module on a TDM10B. > > The std phone is only 2-wire so I know this is not helping. > (yes I have read the 2-wire 4-wire issue) > > I have tried many echocancel values. The best thing to help was > rxgain and txgain. below is my current zapata.conf file > > All help would be grateful. I have tried and tried for 2 weeks > it is rather annoying and irating to hear this delay/echo > > I would call it a delay since you can hear the end of the sentence repeat > over > and over. Also every now and again it sounds like a underwater submarine > with ping and all. > > > Thanks in advance > Barry > > > > [channels] > echocancel = 16 > echocancelwhenbridged = yes > echotraining = no ;; yes > rxgain = -2.0 > txgain = -2.0
If you are in the US and using a digium x100p, then try the following: echotraining=800 echocancel=yes (The values you are showing above aren't even valid parameters.) If you are outside the US, there isn't much you can do since the x100p card was specifically designed to operate with US 600 ohm impedance pstn lines. If you have a x100p clone, it is likely the problem. Replace it with something capable of matching the pstn impedance for whatever country you are located in. _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
