On Thu, Jul 22, 2010 at 11:04 AM, Robert Brock <[email protected]> wrote: > I have had a tie trunk setup between a nortel PBX programmed up as ESS5 trunk > that works great except that the Nortel PBX does not send name when > programmed up as ESS5, when I program up the route as DMS100 to get name and > make the changes to asterisk the trunk doesn't work at all. > > Then trunks connect and the D-ch comes up but there must be a signaling > problem. > > Anyone have programming that works for name and number sent from the Nortel > PBX?
Hi Robert, I had the same issue a few years back when connecting Asterisk to an Option 11. I worked for hours with a Telus rep who really seemed to know his stuff. In the end, we could get get name and number going in different directions with different configs but not in both directions at the same time. I think NI-2 was the closest setting we could get to work at the time. At the time, I think my research led me to believe that I needed to get Q-Sig working but it wasn't far enough along in Asterisk yet. Maybe it has progressed and that might help you. You might also check the FacilityEnable setting to allow sending of Caller Name in a Facility Information Element. I wish I had a set of working configs to send you, but I never did revisit the issue. Perhaps this will give you some pointers that will help. Best Regards, Dave --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
