On 06/09/2017 04:07 AM, Sven Eckelmann wrote:
From: Ben Greear <gree...@candelatech.com> The ath10k firmware doesn't announce its VHT channel width capabilities in the vht_cap information from the "service ready event" arguments. The driver must therefore check whether the 160MHz short GI bit is set and whether the driver still doesn't set the bits for the 160/80+80 MHz capabilities. The two bits for the channel width are a two bit integer and not two separate bits which cannot be parsed without the knowledge of the other bit. Using IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ (b10..) as a mask for this task doesn't make any sense. The correct mask for the VHT channel width should be used instead to make this check more readable.
I didn't test them, but a quick review looks good. Thanks for picking this up! --Ben -- Ben Greear <gree...@candelatech.com> Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k
