Hi, Thanks for your help on my problem "scan is not working in ath5k driver". Few days back I posted a mail regarding "scan is not working in ath5k driver". Now I am sending the ath_info output of my wireless card. I am also sending lspci -vv output of my card. Please tell me if anybody with the same configuration got similar problem.
Already Bruno said that some initialization was missing in AR5213A. lspci -vv output and ath_info output has some differences. lspci -vv is showing AR5212 as my chipset but ath_info is showing AR5213A as my chipset. Please go through the outputs and tell me if my chipset has support in ath5k driver of not. here are the outputs: lspci -vv output: ================================================================= 05:00.0 Ethernet controller: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01) Subsystem: D-Link System Inc D-Link AirPlus DWL-G650 Wireless Cardbus Adapter(rev.C) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 168 (2500ns min, 7000ns max), Cache Line Size 20 Interrupt: pin A routed to IRQ 18 Region 0: Memory at 94000000 (32-bit, non-prefetchable) [size=64K] Capabilities: [44] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=2 PME- ===================================================================== ath_info output: ===================================================================== -==Device Information==- MAC Version: 5213A (0x70) MAC Revision: 5213A (0x79) Device type: 1 2Ghz PHY Revision: 2112a (0x56) -============== EEPROM Information =============- | EEPROM Version: 5.1 | EEPROM Size: 16K | | EEMAP: 2 | Reg. Domain: 0x80D0 | -================= Capabilities ================- | 802.11a Support: no | Turboa disabled: no | | 802.11b Support: yes | Turbog disabled: no | | 802.11g Support: yes | 2GHzXR disabled: no | | RFKill Support: no | 5GHzXR disabled: no | | 32KHz Crystal: no | | -===============================================- /=========================================================\ | Calibration data common for all modes | |=========================================================| | CCK/OFDM gain delta: 01 | | CCK/OFDM power delta: 251 | | Scaled CCK delta: 05 | | 2Ghz Antenna gain: 01 | | 5Ghz Antenna gain: 00 | | Turbo 2W maximum dbm: 38 | | Target power start: 182 | | EAR Start: 1cc | \=========================================================/ /=========================================================\ | Calibration data for 802.11b operation | |=========================================================| | I power: 0x00 | Q power: 0x00 | | Use fixed bias: 0x00 | Max turbo power: 0x00 | | Max XR power: 0x00 | Switch Settling Time: 0x23 | | Tx/Rx attenuation: 0x1c | TX end to XLNA On: 0x00 | | TX end to XPA Off: 0x00 | TX end to XPA On: 0x07 | | 62db Threshold: 0x1c | XLNA gain: 0x0c | | XPD: 0x01 | XPD gain: 0x0a | | I gain: 0x00 | Tx/Rx margin: 0x19 | | False detect backoff: 0x00 | Noise Floor Threshold: -1 | | ADC desired size: -38 | PGA desired size: -80 | |=========================================================| | Antenna control 0: 0x00 | Antenna control 1: 0x02 | | Antenna control 2: 0x25 | Antenna control 3: 0x25 | | Antenna control 4: 0x21 | Antenna control 5: 0x21 | | Antenna control 6: 0x01 | Antenna control 7: 0x26 | | Antenna control 8: 0x26 | Antenna control 9: 0x22 | | Antenna control 10: 0x22 | Antenna control 11: 0x00 | |=========================================================| | Octave Band 0: 0 | db 0: 0 | | Octave Band 1: 3 | db 1: 5 | | Octave Band 2: 0 | db 2: 0 | | Octave Band 3: 0 | db 3: 0 | | Octave Band 4: 0 | db 4: 0 | \=========================================================/ /=========================================================\ | Calibration data for 802.11g operation | |=========================================================| | I power: 0x00 | Q power: 0x10 | | Use fixed bias: 0x01 | Max turbo power: 0x26 | | Max XR power: 0x24 | Switch Settling Time: 0x31 | | Tx/Rx attenuation: 0x1c | TX end to XLNA On: 0x00 | | TX end to XPA Off: 0x00 | TX end to XPA On: 0x0e | | 62db Threshold: 0x1c | XLNA gain: 0x0c | | XPD: 0x01 | XPD gain: 0x0a | | I gain: 0x00 | Tx/Rx margin: 0x19 | | False detect backoff: 0x00 | Noise Floor Threshold: -1 | | ADC desired size: -38 | PGA desired size: -80 | |=========================================================| | Antenna control 0: 0x00 | Antenna control 1: 0x02 | | Antenna control 2: 0x25 | Antenna control 3: 0x25 | | Antenna control 4: 0x21 | Antenna control 5: 0x21 | | Antenna control 6: 0x01 | Antenna control 7: 0x26 | | Antenna control 8: 0x26 | Antenna control 9: 0x22 | | Antenna control 10: 0x22 | Antenna control 11: 0x02 | |=========================================================| | Octave Band 0: 0 | db 0: 0 | | Octave Band 1: 3 | db 1: 5 | | Octave Band 2: 0 | db 2: 0 | | Octave Band 3: 0 | db 3: 0 | | Octave Band 4: 2 | db 4: 28 | \=========================================================/ GPIO registers: CR 00000000 DO 00000000 DI 00000010 ===================================================================== thanks, Jagadish _______________________________________________ ath5k-devel mailing list ath5k-devel@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-devel
