Hi,
I have a CardBus DWL-G630 that is running very happily with ath5k using
the mainline driver in 2.6.29. The only problem is that the leds do not
flash (as they do with madwifi) and so it is hard to tell if the card is
associated.
I notice that led support is a current WIP.
Could you give me some advice as to whether I just need to find the
correct pin/polarity for this card, or something more fundamental is
required.
Thanks
Mark
02:00.0 Ethernet controller: Atheros Communications Inc. AR2413 802.11bg NIC
(rev 01)
Subsystem: D-Link System Inc AirPlus G DWL-G630
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size: 128 bytes
Interrupt: pin A routed to IRQ 5
Region 0: Memory at 44000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
Kernel driver in use: ath5k
Kernel modules: ath5k
_______________________________________________
ath5k-devel mailing list
ath5k-devel@lists.ath5k.org
https://lists.ath5k.org/mailman/listinfo/ath5k-devel
