I have configured my laptop in access point mode at 2.412 GHz. I am trying to change that to the 5GHz range. So far i am not able to do so.
Does atheros 9K support the 5Ghz operating frequency in both 20Mhz and 40Mhz for 802.11n ? If yes how do i set the parameters to enable this feature? Currently it is set at 2.412 GHz. The hostapd.conf is as follows: driver=nl80211 interface=wlan1 ssid=xxxxxxx channel=1 hw_mode=g auth_algs=1 ieee80211n=1 wme_enabled=1 wmm_enabled=1 ht_capab=[TX-STBC][RX-STBC] On running iw list, the 5 GHz channels are set to passive scanning Band 2: Capabilities: 0x11ef RX LDPC HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 8 usec (0x06) HT TX/RX MCS rate indexes supported: 0-15 Frequencies: * 5180 MHz [36] (20.0 dBm) (passive scanning, no IBSS) * 5200 MHz [40] (20.0 dBm) (passive scanning, no IBSS) * 5220 MHz [44] (20.0 dBm) (passive scanning, no IBSS) * 5240 MHz [48] (20.0 dBm) (passive scanning, no IBSS) * 5260 MHz [52] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5280 MHz [56] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5300 MHz [60] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5320 MHz [64] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5500 MHz [100] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5520 MHz [104] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5540 MHz [108] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5560 MHz [112] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5580 MHz [116] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5600 MHz [120] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5620 MHz [124] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5640 MHz [128] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5660 MHz [132] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5680 MHz [136] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5700 MHz [140] (20.0 dBm) (passive scanning, no IBSS, radar detection) * 5745 MHz [149] (20.0 dBm) (passive scanning, no IBSS) * 5765 MHz [153] (20.0 dBm) (passive scanning, no IBSS) * 5785 MHz [157] (20.0 dBm) (passive scanning, no IBSS) * 5805 MHz [161] (20.0 dBm) (passive scanning, no IBSS) * 5825 MHz [165] (20.0 dBm) (passive scanning, no IBSS) How do i change this? Thanks! _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel