On Mon, Jul 9, 2012 at 12:15 PM, Dhruv Naithani <dhruv...@buffalo.edu> wrote: > I have configured my laptop in access point mode at 2.412 GHz. I am > trying to change that to the 5GHz range. So far i am not able to do > so.
related thread http://www.mail-archive.com/ath9k-devel@lists.ath9k.org/msg05989.html > > Does atheros 9K support the 5Ghz operating frequency in both 20Mhz and > 40Mhz for 802.11n ? If yes how do i set the parameters to enable this > feature? > > Currently it is set at 2.412 GHz. > The hostapd.conf is as follows: > > driver=nl80211 > interface=wlan1 > ssid=xxxxxxx > channel=1 > hw_mode=g > auth_algs=1 > ieee80211n=1 > wme_enabled=1 > wmm_enabled=1 > ht_capab=[TX-STBC][RX-STBC] > > > On running iw list, the 5 GHz channels are set to passive scanning > > Band 2: > Capabilities: 0x11ef > RX LDPC > HT20/HT40 > SM Power Save disabled > RX HT20 SGI > RX HT40 SGI > TX STBC > RX STBC 1-stream > Max AMSDU length: 3839 bytes > DSSS/CCK HT40 > Maximum RX AMPDU length 65535 bytes (exponent: 0x003) > Minimum RX AMPDU time spacing: 8 usec (0x06) > HT TX/RX MCS rate indexes supported: 0-15 > Frequencies: > * 5180 MHz [36] (20.0 dBm) (passive scanning, no IBSS) > * 5200 MHz [40] (20.0 dBm) (passive scanning, no IBSS) > * 5220 MHz [44] (20.0 dBm) (passive scanning, no IBSS) > * 5240 MHz [48] (20.0 dBm) (passive scanning, no IBSS) > * 5260 MHz [52] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5280 MHz [56] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5300 MHz [60] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5320 MHz [64] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5500 MHz [100] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5520 MHz [104] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5540 MHz [108] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5560 MHz [112] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5580 MHz [116] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5600 MHz [120] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5620 MHz [124] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5640 MHz [128] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5660 MHz [132] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5680 MHz [136] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5700 MHz [140] (20.0 dBm) (passive scanning, > no IBSS, radar detection) > * 5745 MHz [149] (20.0 dBm) (passive scanning, no > IBSS) > * 5765 MHz [153] (20.0 dBm) (passive scanning, no > IBSS) > * 5785 MHz [157] (20.0 dBm) (passive scanning, no > IBSS) > * 5805 MHz [161] (20.0 dBm) (passive scanning, no > IBSS) > * 5825 MHz [165] (20.0 dBm) (passive scanning, no > IBSS) > > How do i change this? > Thanks! > _______________________________________________ > ath9k-devel mailing list > ath9k-devel@lists.ath9k.org > https://lists.ath9k.org/mailman/listinfo/ath9k-devel -- thanks, shafi _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel