Am Freitag, den 02.08.2013, 09:53 +0200 schrieb YuGiOhJCJ Mailing-List: > > avrdude: set SCK frequency to 16000 Hz > avrdude: warning: cannot set sck period. please check for usbasp > firmware update.
This warning shows, that your programmer cannot change the SPI clockrate. > avrdude: error: programm enable: target doesn't answer. 1 > avrdude: initialization failed, rc=-1 > Double check connections and try again, or use -F to override > this check. Thats the point. Perhaps, the clock rate of you controller is too low. Is there any jumper on your programmer to slow down the clock? My cheap chinese programmer has a jumper called "speed". If your Computer has got a parallel printer port, there is a solution to build a programmer with nearly no parts. All you need is a sub-d-plug, a piece of flat ribbon cable and a connector to your target system. (and a soldering tool) Of course you have to inform avrdude about this hardware. If needed, i will look for details, i used such a "programmer" some time ago very successfully, before i used a computer without parallel port. -- Mit freundlichen Grüßen / kind regards Andreas Graebe _______________________________________________ AVR-chat mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/avr-chat
