On Thu, 2013-08-08 at 08:29 +0200, YuGiOhJCJ Mailing-List wrote: > And this is the attached file. > I went to the link printed on the circuit board and followed it here: http://www.aliexpress.com/store/product/1LOT-1PCS-USBasp-AVR-Programmer-1PCS-CNT-004-Adapter-1PCS-10PIN-65CM-Wire-Free-shipping/812021_1087050891.html it says that this usbasp is modified to automatically find the correct speed so use the latest avrdude but leave out the -B switch, like this: $ sudo avrdude -p t2313 -c usbasp -v Don't forget the correct wiring. > > - My target micro-controller attiny2313 clock is lower than 1.5 MHz > > - So, I need to put a jumper (J3) between the pin 25 of the usbasp > > programmer internal micro-controller atmega8 and the GND (pin 3, pin 5 or > > pin 21). > > From the picture they did not put a jumper or holes for a jumper.
> > We can verify this information in the README file[1] and in the schematic > > image[2] of the usbasp programmer. > > > > I have opened the usbasp to see how I can set the jumper of the usbasp. > > > > As you can see in the attached image, this is very little and I don't know > > how to wire the pin 25 to the GND correctly. > > > > Can you give me an advice on how I can wire the pin25 and the GND easily ? > > The above link says that this unit is modified from the opensource version on the fischl.de site so the information there doesn’t quite apply. Best regards. -- Ormund _______________________________________________ AVR-chat mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/avr-chat
