Hi, I have checked scenarios according to the feedback given by you people, but its not fulfilling our requirements. So...
The scenario is as follows: BOM line for notebook is Paper 198 pages Paper stock in WH1 - 50pages Paper stock in WH2 - 100pages Paper stock in WH3 - 20pages When Master planning is run, system should not consider the stock lying in WH3. Any solution to address this scenario? --- In Axapta-Knowledge-Village@yahoogroups.com, "visti Sethna" <[EMAIL PROTECTED]> wrote: > > Yes This kind of coverage is possible. > > In Inventory Management => Setup => Dimensions => Dimension Groups. > > Select you dimension group that you are using, > > Under storage dimensions activation & setups => In overview tab, select > Warehouse ( ensuring warehouse is active) > > In General Tab => Coverage, select the check box for coverage plan by > dimension. > > Hope this satisfies your requirement. > > Regards > Visti > 9833213532 > > On Tue, Oct 7, 2008 at 9:44 AM, puneet.darji <[EMAIL PROTECTED]> wrote: > > > Is it possible to exclude the stock lying in a specific warehouse in > > Master Planning. > > > > Scenario: > > --------- > > WH1(warehouse) is having 10 Kg of Aluminum. > > WH2(warehouse) is having 12 Kg of Aluminum. > > > > Suppose I raise requirement of 14 Kg of Aluminum. > > > > Now when I run Master Planning engine it should not consider WH1 and > > should consider WH2 only.So my net requirement would be now only 2 Kg > > of Aluminum(as WH2 is having only 12 Kg of Aluminum). > > > > Thanks and regards: > > Puneet > > > > > > >
