Hi Craig,
One reason for this error could be that the port used by the Workflow site is
already in use. check out your IIS and if so, rectify the same.
Regards,
Yatin
--- On Tue, 30/6/09, Craig Fidler <cfid...@bs3.co.za> wrote:
From: Craig Fidler <cfid...@bs3.co.za>
Subject: [Axapta-Knowledge-Village] WORKFLOW ERROR
To: "Axapta-Knowledge-Village@yahoogroups.com"
<Axapta-Knowledge-Village@yahoogroups.com>
Date: Tuesday, 30 June, 2009, 1:04 AM
Hi All,
Anyone get the following error when deploying Workflow. Using Server 2008
An error occurred during setup of Workflow.
Reason: This access control list is not in canonical form and therefore cannot
be modified.
Workflow was left in a partially installed state. Review the log messages to
determine whether you can manually finish the installation. If not, then you
need to: 1) Rerun Setup and choose the option to remove Workflow. 2) Correct
the system problem that caused the error. 3) Rerun Setup and install Workflow
again.
=== Rolling back setup of Workflow due to error ===
Launching MSI: /i "D:\Software\ Ax 2009\Msi\Components 32\Components32. msi"
/qb-! /l*v "C:\ProgramData\ Microsoft\ Dynamics AX\Dynamics AX Setup
Logs\2009-06- 29 21-31-02\Components 32 Rollback Log.txt" DIRECTEXECUTE= 1
SETUPLANGUAGE= EN INSTALLDIR="C:\Program Files\Microsoft Dynamics AX\50"
INSTALLDIR32="C:\Program Files\Microsoft Dynamics AX\50"
ADDLOCAL="ClientUI,Enterprise Portal,NetBusine ssConnector, Debugger,
EnterprisePortal Tools,ReportingT ools,Workflow, ClientConfig" REMOVE="Workflow"
=== Rolling back setup of Workflow due to error ===
Rollback of === Rolling back setup of Workflow due to error ===
installation has been completed. For details about why the installation
failed, see the previous messages in the log.
=== Setup was canceled or failed. For details see the previous messages in the
log.
=== Setup logging ended: 29/06/2009 09:33:02 PM ErrorLevel/ExitCode : '1' ===
Thanks
Craig
Cricket on your mind? Visit the ultimate cricket website. Enter
http://cricket.yahoo.com
