On Monday 19 September 2005 06:17, JeDi wrote:
> Hi Richard,
>
> Any chance you found your working (with framebuffer output) x50v
> kernel and initrd yet? Cause I have some spare time today, and I
> wanted to work on it a bit (as far as possible without serial cable).
> I tried setting the GPIOs for irda as you suggested, but that didn't
> work (again...). I really think the kernel doesn't get far while
> booting. If only I had a way to check it out...
>
> Greetz,
> JeDi

I did, actually, find my booting kernel w/ framebuffer support.

http://bateman.dhs.org/~richard/tmp/arm/

use those files.  rootfs.img.bz2 when unbziped is an ext2 image that I put on 
the root of my sd card that gets automounted (if the sd card you have 
works... aparently there are a few that don't).

For me, using this haret, default.txt, and initrd, this boots up to a serial 
console with a framebuffer enabled that shows you system messages and such.

What I haven't gotten (because I ran into some technical difficulties) is a 
kernel compiled from one of my source trees that works.  this one was 
compiled awhile back, and I don't remember which tree it came from :-/

I'll try to figure that out, but in the mean time you should be able to at 
least see what it ought to look like here

Richard
-- 
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port

Reply via email to