Hi Philip,
I searched long and hard for fully-connected cable and had no luck, in
the end I bought the connector assembly from www.gomadic.com and built
the cable myself. The connector assembly has unbelievably small posts to
solder to, it was quite a chore to do it neatly; www.gomadic.com also
have a version of the connector with the 5 serial wires pre-soldered for
you.
I think you'll find the USB cable just has the minimum wiring for the
USB functionality.
The make and model of the Touchscreen chip is listed on the website as a
Texas Instruments ADS 7846N. I have personal experience in trying to get
information out of TI and its not easy, basically if you cant find it on
their website you'll have a tough time getting it from them directly -
"we don't directly support end-users" etc.
http://handhelds.org/moin/moin.cgi/DellAximX50Hardware
This appears to be the only in-depth document about the chip listed on
their website: http://focus.ti.com/lit/ds/symlink/ads7846.pdf
--
Michael Cutler . o O ( http://blog.lobstertechnology.com/ )
PGP: 0xC3ABA735
Philip Trickett (List) wrote:
Hi,
Just got an X50v, and I have been following the list for a few months
now.
I have a couple of questions:
Does anyone know where I can get a cable with all the conductors
connected? Does the USB one that comes with the Axim have all the
connections within the cable?
For the touchscreen, does anyone have the make and model number of the
touchscreen chip? I was going to go on a trawl for documentation with
regard to the position reporting.
Cheers,
Phil
P.S. Is it possible to use the USB serial console (ttyUSB0) during boot?
I remember being able to do that when I had an iPaq 3630.
--
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port