On 2/10/07, Pierre GAUFILLET <[EMAIL PROTECTED]> wrote:

 Well, I tested quite a few SSP configurations for TSC2046...

 The current ads7846_adc_ssp.c does not work for Axim X50 family.
 I had to modify ads7846_init_chip() to get something, in the following way
:
     SSCR0_P(port) = 0;
    pxa_set_cken(CKEN23_SSP1, 1);
    SSCR0_P(port) |= SSCR0_DataSize(12); /* 12 bits */
    SSCR0_P(port) |= SSCR0_Motorola;
    SSCR0_P(port) |= 0x11 << 8; /* ~100 KHz */

Btw, this is the same on pxa25x and pxa27x?
The hx4700 (24bit) driver used SSCR0_Motorola and (0x6 << 8).

    SSCR1_P(port) = 0;
    SSCR0_P(port) |= SSCR0_SSE;

What is the difference between Motorola SPI and National
Semiconductor's Microwire mode?

 Even with these modifications, all I get is x=2048, y=2048...

I tried this, too, and I get the same. (Communication with
SSCR0_National works here, though).

 Communications on 24 bits as in my previous patch seems the only stable
configuration.
 I do not understand why : there is no special constraint at this level in
the TSC 2046 datasheet...
 Nervertheless, I then get linear measurements in the [5000, 30000]x[5000,
30000] range, that seem useable.

With the driver as-is I sometimes get oscillating Y measurements.
Trying to get a result by averaging causes some noise in the Y signal.

regards
Philipp
--
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port

Reply via email to