Per SDHCI 3.0+, HOST_CONTROL2's UHS Mode Select is bits 0..2 (3 bits) and bit 3 is the 1.8 V Signaling Enable. The current SDHCI_CTRL_UHS_MASK of GENMASK(3, 0) is one bit too wide and clears 1.8 V signaling every time sdhci_set_uhs_signaling() runs.
Shrink the mask to GENMASK(2, 0) and add SDHCI_CTRL_VDD_180 = BIT(3) so controllers that need to drive 1.8 V on I/O for HS200/HS400/UHS modes can OR the bit in without it being clobbered on the next set_clock(). No functional change for controllers where VDD_180 was unused (most in-tree drivers do not touch it; voltage switching there is either fixed by board wiring or handled by an external regulator). Assisted-by: Claude Opus 4.7 <[email protected]> Signed-off-by: Sascha Hauer <[email protected]> --- drivers/mci/imx-esdhc-common.c | 2 -- drivers/mci/sdhci.h | 3 ++- 2 files changed, 2 insertions(+), 3 deletions(-) diff --git a/drivers/mci/imx-esdhc-common.c b/drivers/mci/imx-esdhc-common.c index 050621d7fb..eb6a71915f 100644 --- a/drivers/mci/imx-esdhc-common.c +++ b/drivers/mci/imx-esdhc-common.c @@ -12,8 +12,6 @@ #define ESDHC_CTRL_D3CD 0x08 -#define SDHCI_CTRL_VDD_180 0x0008 - #define ESDHC_MIX_CTRL 0x48 #define ESDHC_MIX_CTRL_DDREN (1 << 3) #define ESDHC_MIX_CTRL_AC23EN (1 << 7) diff --git a/drivers/mci/sdhci.h b/drivers/mci/sdhci.h index 8d21febd7a..a04eb5b7ed 100644 --- a/drivers/mci/sdhci.h +++ b/drivers/mci/sdhci.h @@ -132,13 +132,14 @@ #define SDHCI_SIGNAL_ENABLE 0x38 #define SDHCI_ACMD12_ERR__HOST_CONTROL2 0x3C #define SDHCI_HOST_CONTROL2 0x3E -#define SDHCI_CTRL_UHS_MASK GENMASK(3, 0) +#define SDHCI_CTRL_UHS_MASK GENMASK(2, 0) #define SDHCI_CTRL_UHS_SDR12 0x0 #define SDHCI_CTRL_UHS_SDR25 0x1 #define SDHCI_CTRL_UHS_SDR50 0x2 #define SDHCI_CTRL_UHS_SDR104 0x3 #define SDHCI_CTRL_UHS_DDR50 0x4 #define SDHCI_CTRL_HS400 0x5 /* Non-standard */ +#define SDHCI_CTRL_VDD_180 BIT(3) #define SDHCI_CTRL_DRV_TYPE_MASK GENMASK(5, 4) #define SDHCI_CTRL_DRV_TYPE_B 0x0000 #define SDHCI_CTRL_DRV_TYPE_A 0x0010 -- 2.47.3
