Michael Buesch wrote:
> On Wednesday 30 May 2007 22:07:29 Markus Rothe wrote:
>> Hello,
>>
>> I'm trying to use bcm43xx_mac80211 module from wireless-dev git
>> (checked out today). Unfortunately I've some problems. The device is
>> not recognized. I cannot "ifconfig ethx up" for example.
>>
>> From dmesg:
>>
>> [...]
>> ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x04, vendor 0x4243)
>> ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x05, vendor 0x4243)
>> ssb: Core 2 found: PCMCIA (cc 0x80D, rev 0x02, vendor 0x4243)
>> ssb: Core 3 found: V90 (cc 0x807, rev 0x02, vendor 0x4243)
>> ssb: Core 4 found: PCI (cc 0x804, rev 0x09, vendor 0x4243)
>> ssb: Switching to ChipCommon core, index 0
>> ssb: Switching to PCI core, index 4
>> ssb: Sonics Silicon Backplane found on PCI device 0000:02:03.0
>> bcm43xx_mac80211: Broadcom 4306 WLAN found
>> ssb: Switching to IEEE 802.11 core, index 1
>> bcm43xx_mac80211: Found PHY: Analog 2, Type 2, Revision 2
>> bcm43xx_mac80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
>> bcm43xx_mac80211: Radio turned off
>> wmaster0: Failed to select rate control algorithm
>> wmaster0: Failed to initialize rate control algorithm
>> bcm43xx_mac80211: probe of ssb0:0 failed with error -2
>>
>> $ lsmod
>> Module                  Size  Used by
>> snd_pcm_oss            32160  0 
>> snd_mixer_oss          12928  2 snd_pcm_oss
>> snd_seq_oss            24960  0 
>> snd_seq_device          5384  1 snd_seq_oss
>> snd_seq_midi_event      5504  1 snd_seq_oss
>> snd_seq                37168  4 snd_seq_oss,snd_seq_midi_event
>> nvidia               4539476  12 
>> bcm43xx_mac80211      382688  0 
>> mac80211              114692  1 bcm43xx_mac80211
>> cfg80211               12936  1 mac80211
>> snd_intel8x0           26140  1 
>> snd_ac97_codec         87456  1 snd_intel8x0
>> ac97_bus                2048  1 snd_ac97_codec
>> snd_pcm                52232  3 snd_pcm_oss,snd_intel8x0,snd_ac97_codec
>> snd_timer              15364  2 snd_seq,snd_pcm
>> snd_page_alloc          7176  2 snd_intel8x0,snd_pcm
> 
> You must load the rate control algorithm module
> rc80211-simple, for example.
> 

That loads automatically here.

Why isn't the ssb module shown in the lsmod list?

Larry

_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev

Reply via email to