I am having some trouble with the AM2315 Temp\Humidity sensor. I have it hooked up to my BeagleBone Black as described below with the addition of a 10k resistor from White to red and another one from yellow to red. When its all hooked up and I run i2cdetect, it loads up to 5B really fast and then it slowly (about 1 per second, in red below) loads each address after that until it gets to the end.. but never shows the AM2315 at 5C. I have tried multiple i2c buses and 4.7k resistors but get the same thing. Any ideas?
Red: 3v3 White: P9_21 Yellow: P9_20 Black: GND i2cdetect -y -r 1 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- -- -- -- -- -- -- -- root@arm:~# i2cget -y 1 0x5C 0x03 b Error: Read failed -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.