HiAll, I have built kernel version 3.13.5 for the Beagleboard-xM. At boot it hangs at "Starting kernel ..." (see capture below). Has any one had success with 3.13?
Regards, Ralph U-Boot SPL (Feb 28 2014 - 11:58:43) reading u-boot.img reading u-boot.img U-Boot 2014.04-rc1-00190-geeb72e6 (Feb 28 2014 - 11:59:40) OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz OMAP3 Beagle board + LPDDR/NAND I2C: ready DRAM: 512 MiB NAND: 0 MiB MMC: OMAP SD/MMC: 0 *** Warning - readenv() failed, using default environment In: serial Out: serial Err: serial Beagle xM Rev C Timed out in wait_for_event: status=0000 Check if pads/pull-ups of bus 1 are properly configured No EEPROM on expansion board Die ID #023200029ff80000016849a90301801c Net: usb_ether Hit any key to stop autoboot: 0 mmc0 is current device gpio: pin 173 (gpio 173) value is 0 gpio: pin 4 (gpio 4) value is 0 SD/MMC found on device 0 reading uEnv.txt 106 bytes read in 3 ms (34.2 KiB/s) Loaded environment from uEnv.txt Importing environment from mmc ... ** File not found /boot/uImage ** Booting from nand ... no devices available Wrong Image Format for bootm command ERROR: can't get kernel image! 2692216 bytes read in 212 ms (12.1 MiB/s) 15670 bytes read in 45 ms (339.8 KiB/s) Booting with DT from mmc0 ... Kernel image @ 0x80200000 [ 0x000000 - 0x291478 ] ## Flattened Device Tree blob at 80f80000 Booting using the fdt blob at 0x80f80000 Using Device Tree in place at 80f80000, end 80f86d35 Starting kernel ... -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.