Hi All, I would like to say my problem, I would like to write some code for PRU units for that reason I enabled PRU on BBB and I run prepared examples on BBB.
But I don't know how can I create a project and compile. for example there is a software below but I don't know how can I complie it and how can I run it? #define GPIO1 0x4804c000 #define GPIO_CLEARDATAOUT 0x190 #define GPIO_SETDATAOUT 0x194 MOV r1, 10 BLINK: MOV r2, 7<<22 MOV r3, GPIO1 | GPIO_SETDATAOUT SBBO r2, r3, 0, 4 MOV r0, 0x00a00000 DELAY: SUB r0, r0, 1 QBNE DELAY, r0, 0 MOV r2, 7<<22 MOV r3, GPIO1 | GPIO_CLEARDATAOUT SBBO r2, r3, 0, 4 MOV r0, 0x00a00000 DELAY2: SUB r0, r0, 1 QBNE DELAY2, r0, 0 SUB r1, r1, 1 QBNE BLINK, r1, 0 It is possible could you give some information about it? Best Regards, Eren Basturk -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.