There are resistors on the lines, worse case scenarion I can take them off.
But tgose lines are used for lcd cape already so it does work, whats the
problem?
Dnia 8 października 2014 19:06:54 Gerald Coley <ger...@beagleboard.org>
napisał(a):
I doubt it will work but you are free to try. Adding two loads such as that
on those pins is asking for trouble.
Gerald
On Wed, Oct 8, 2014 at 1:50 AM, bremenpl <breme...@gmail.com> wrote:
> Hello there,
> I am currently working on a motherboard for the BeagleBone Black. One of
> the requiments is to have a HDMI output on the side of the motherboard. I
> Know that there are LCD pins on the BeagleBone Black header and there is a
> possibility to connect a LCD cape. I was wondering either it would work to
> duplicate the NXP HDMI framer circuit that is on the board to the
> motherboard and use it for hdmi output? If I am correct the only difference
> would be that there is no acces to I2C0 from headers so I would have to use
> I2C1/2 for the NXP chip. That way at least I wont chave to worry about
> addressing 2 chips at once (not sure If you can change address of the hdmi
> framer yet).
>
> My question is, would this solution be bard to implement in software, or
> is it easy to change the I2C bus config for hdmi? Are there any obstacles
> that I am not aware of? I would really aprichiate any help in here.
>
> --
> For more options, visit http://beagleboard.org/discuss
> ---
> You received this message because you are subscribed to the Google Groups
> "BeagleBoard" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to beagleboard+unsubscr...@googlegroups.com.
> For more options, visit https://groups.google.com/d/optout.
>
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to a topic in the
Google Groups "BeagleBoard" group.
To unsubscribe from this topic, visit
https://groups.google.com/d/topic/beagleboard/85MgiQg0wJY/unsubscribe.
To unsubscribe from this group and all its topics, send an email to
beagleboard+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to beagleboard+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
