By "older" I mean something in the range of 4.1.x lol I have found they're much faster than the older image I was currently working with. *bone47
On Thu, Aug 6, 2015 at 6:03 PM, William Hermans <yyrk...@gmail.com> wrote: > *is it showing up under:* >> >> * sudo ifconfig -a ??* >> > > No. > > *i've been mostly testing on the v4.1.x-ti branch, so something might* >> * have broke on mainline..* >> >> * Do the other 2 serial ports show up?* >> >> * dmesg | grep serial* >> > > william@xanbustester:~$ dmesg |grep serial > [ 2.803479] 44e09000.serial: ttyS0 at MMIO 0x44e09000 (irq = 154, > base_baud = 3000000) is a 8250 > > Robert, Give me a bit to make sure this is not my fault. > > First - > > william@xanbustester:~$ dtc -v > Version: DTC 1.4.0 > > So this is the wrong version. Had to hack together /opt/scripts from an > older wheezy 7.8 image, but I've got it in place now. About to start over > from installing dtc. > > Also, I installed canutils *before* putting this image on the board in > question. I kind of doubt that is the problem, but not discounting that > possibility. > > So yeah give me a little bit to poke around, and if it's not going to work > . . .feel free to recommend me an "older" more suitable image. It'll be a > slight hassle to go into uEnv.txt to make changes, and run depmod, but > honestly thats all pretty easy . . . It will be harder to slim down the > image again and uh . . . other stuff. > > On Thu, Aug 6, 2015 at 5:40 PM, Robert Nelson <robertcnel...@gmail.com> > wrote: > >> On Thu, Aug 6, 2015 at 7:38 PM, William Hermans <yyrk...@gmail.com> >> wrote: >> > Anyway, yeah, not working. >> >> is it showing up under: >> >> sudo ifconfig -a ?? >> >> i've been mostly testing on the v4.1.x-ti branch, so something might >> have broke on mainline.. >> >> Do the other 2 serial ports show up? >> >> dmesg | grep serial >> >> Regards, >> >> -- >> Robert Nelson >> https://rcn-ee.com/ >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to beagleboard+unsubscr...@googlegroups.com. >> For more options, visit https://groups.google.com/d/optout. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.