you will also need a copy of Electrical Engineering 101 by Ashey. You'll probably want to read it before going further.
On Mon, Feb 27, 2017 at 2:53 PM, William Hermans <[email protected]> wrote: > > > On Mon, Feb 27, 2017 at 12:32 PM, Andrew Kirch <[email protected]> > wrote: > >> you likely don't need an overlay, simply modify /sys at boot to mux the >> pins to serial.. >> > > That would take an awful lot of work, and knowledge compared to simply > loading an overlay at boot, or interactively from the command line. The > overlays already exist too. They're in /lib/firmware > > The point i was trying to make anyhow, is that it wont work just because > you've connected hardware to hardware, and that you need to mux the pins, > and load the serial driver module. Which an overlay makes pretty simple. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit https://groups.google.com/d/ > msgid/beagleboard/CALHSORqE5GKQUE4MjjKo3fP7KNNihJaa4_aF5d6ZYN_YL%3D9ekg% > 40mail.gmail.com > <https://groups.google.com/d/msgid/beagleboard/CALHSORqE5GKQUE4MjjKo3fP7KNNihJaa4_aF5d6ZYN_YL%3D9ekg%40mail.gmail.com?utm_medium=email&utm_source=footer> > . > > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CALA5tJJ6jsiBiX1gicKDivwsz7wyjpMOPNhfPRM%2BsQr2WRnHMQ%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
