Hi Jorge,
I read the draft, and have the following questions:
1) on section 1.2 Inter-subnet Forwarding for Prefix Routes in the
Interface-less IP-VRF-to-IP-VRF Model
The RT-1 per EVI route of ESI1 in Figure 2 is not an IP A-D per EVI route,
but a normal Ethernet A-D per EVI route,
in other words, its MPLS label identifies a BD, not an IP-VRF.
is my understanding correct?
In RFC9136 Interface-less IP-VRF-to-IP-VRF Model,
the inter-subnet-forwarding from H3 to H1 will pass through PE1/PE2's
IP-VRF instance via the MPLS label of the IP-VRF's instance,
but in the RFC9316 Bump-in-the-wire instance,
the inter-subnet-forwarding from H3 to H1 will not pass through PE1/PE2's
IP-VRF instance because of the RT-1 per EVI route's MPLS Label's L2 context.
But this section refers to both the above two use cases of RFC9136,
So which behavior will be followed by this use case?
2) On section 5.3 Constructing the EVPN IP Routes
Is the RT-5 construction of the second use case (section 1.2) the same as
the third use case (section 1.3) ?
I mainly concerns the Route Targets and the Ethernet Tag ID of the RT-5
routes.
especailly when the BD (to which the ESI of section 1.2 is attched) is of
VLAN-aware service interface.
3) On section 5.3.1 Route Resolution
Is the Route Resolution of the second use case (section 1.2) the same as
the third use case (section 1.3) ?
Will the route resolution of the second use case(section 1.2) need a BD and
an IRB interface on PE3?
I note that in RFC9136 section 4.3 Bump-in-the-wire use case,
the RT-1 per EVI route is advertised in a normal BD. It says that:
(1) Assuming TS2 is the active TS in ESI23, NVE2 advertises the
following BGP routes:
* Route type 1 (Ethernet A-D route for BD-10) containing: ESI =
ESI23 and the corresponding tunnel information (VNI field),
as well as the BGP Encapsulation Extended Community as per
[RFC8365].
* Route type 5 (IP Prefix route) containing: IPL = 24, IP =
SN1, ESI = ESI23, and GW IP address = 0. The EVPN Router's
MAC Extended Community defined in [RFC9135] is added and
carries the MAC address (M2) associated with the TS behind
which SN1 sits. M2 may be learned by policy; however, the
MAC in the Extended Community is preferred if sent with the
route.
This RT-1 per EVI route will not just be used by the RT-5 routes for IP
forwarding,
it will also be used by the MAC forwarding of BD-10.
When it is used in IP forwarding and MAC forwarding, it will be the same
route.
If this is correct, it will need a BD on PE3 to be resolved to.
Thanks,
Yubao_______________________________________________
BESS mailing list
BESS@ietf.org
https://www.ietf.org/mailman/listinfo/bess
