On Dec 27, 9:05 am, Paul Cooley <[email protected]> wrote:
> Anyway, drilling the stainless steel was no problem thanks to all the
> advice. I still can't seem to drill exactly in the center of
> anything, but it's close enough.
Careful measurement, and using a good center punch to set a spot for
the bit to settle into when starting to drill have always helped me
out. Glad to hear that you have your fenders installed successfully.
My criteria were for my install were reasonably even distance from the
wheel when viewed from the side, and most important, no rattling when
riding. I occasionally have to bend the stays on my VO fenders to get
things exactly lined up again if they get bumped.
Steve Fuller
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups
"Bicycle Lifestyle" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/bicyclelifestyle?hl=en
-~----------~----~----~----~------~----~------~--~---
