Hi Andrew:

I also have a Cobolt I sent them a message and they replaced it gladly. I had 
to ship the
defective one to them which cost me around $12.

Cheers
Guy Castonguay
Ottawa, Canada

--- [EMAIL PROTECTED] wrote:

> Hi where is the vox tape available from as I bought the cobolt unit and as 
> soon as the year
> guarantee passed it packed up dont know if I had a bad one or they are just 
> crap as I was very
> careful with it and never droped it and always kept it in the pouch supplied 
> away from magnetic
> fields   or rf   I hope this other unit is more sturdy I would be grateful on 
> other peoples
> feedback on these two products. best wishes everyone Andrew 
>   ----- Original Message ----- 
>   From: Tom Fowle 
>   To: blindhandyman@yahoogroups.com 
>   Cc: [EMAIL PROTECTED] 
>   Sent: Wednesday, October 24, 2007 7:12 PM
>   Subject: [BlindHandyMan] VoxTape talking tape measure manual
> 
> 
>   Hi all,
>   I don't think anybody has previously posted the manual for this tape 
>   Voxtape from Caretec.
>   This is the slightly more expensive one that uses a single AA battery.
>   It has some advantages over the Cobolt, but appears to use the same 
> sprockett
>   technology to read the tape.
>   Note they say you should use the spring loaded rewind system to avoid
>   errors, I often find unless the tape has been allowed to rewind solidly into
>   the case that it's a sixteenth off. some differences are;
> 
>   has on/off button;
>   Current measurement can be set to zero so that moving the tape
>   gets you the difference between last and current measure.
>   has seperate buttons for measuring with and without case, not a toggle.
> 
>   The speech sounds very much like the Cobolt unit but of much lower quality.
>   This was probably done to save power thus allowing the use of the AA cell.
> 
>   A good giggle is to be had as they say there is a 1 year
>   warranty on the speech output.
>   We assume this means no warranty on the tape!
> 
>   Neither of these tapes has what I want, an ability to enter a measurement
>   and then "find" it.
> 
>   Find below, in the message body, a text rendering of the print manual.
>   which is apparrently the only thing they provide on a single sheet of paper.
> 
>   It scanned very poorly and took my assistant David a lot of proofing.
> 
>   I don't know which I would buy if I wanted one, neither of them makes me 
>   really happy.
>   Tom
> 
>   CARETEC: Stubenbastei 1
>   A-1010 Wien (Austria)
>   Tel: (00431) 513 80 81-0; Fax:-9
>   [EMAIL PROTECTED] www.caretec.at
> 
>   USER'S MANUAL
>   VOX-Tape - talking tape measure
> 
>   Description of the device
>   Put the device in front of you so that the front side with the keys is
>   facing you. On this side of the device you will find two rows with 5 keys
>   (two in the upper row and three in the lower row). On the bottom side of
>   the device you will find the ribbed lid of the battery compartment and on
>   the reverse of the case a clip for attaching it to your belt. On the left
>   side of the case you will find the tape end, which can easily be accessed
>   and pulled forward. On the upper, round end of the device (inclined towards
>   the right), you will find a ribbed button to retract the tape. It should
>   always be retracted this way, otherwise it may lead to inaccurate
>   measurements.
> 
>   CAUTION:
>   If the tape is extended more then 1 foot (30 cm), take care when retracting
>   the tape to avoid injuries to your hand. Right behind this retraction
>   button, you will feel some small holes, housing the outlet of the
>   loudspeaker. Please do not cover them or it may lead to a bad speech
>   output.
> 
>   Description of the keys
>   Upper row
>   Right key: Press once: turn the tape on / measurement
>   Hold: turn the tape off
>   Left key: Press once: measurement with case
>   Hold: metric or imperia1 system
> 
>   Lower row
>   Right key: Press once: add value to memory
>   hold: change volume
>   Middle key: Press once: retain current value
>   hold: set to zero or standard measurement
>   Left key: press once: recall total value in memory
>   hold: delete memory
> 
>   How to start
>   Pull the lid of the battery compartment to the right and open it. Put one
>   1.5 V battery in the compartment, with the smooth side negative of the
>   battery to go in first. Close the lid of the compartment until it locks in
>   place, a signal tells you that your VOX-Tape is ready for measuring.
> 
>   Turn the tape off
>   The VOX-Tape will automatically shut off after 90 seconds. If you want to
>   turn it off before that, just keep the right button of the upper row
>   pressed for at least 2 seconds. Release the button after you hear the
>   second beep. You will then hear a signal telling you, the tape has been
>   switched off.
> 
>   Measurement
>   Press the upper right key to switch the tape on. You will hear a signal,
>   showing you that the tape is ready for measuring. If the tape was not
>   retracted properly, VOX-Tape will announce “error - tape is not in the
>   case”. Press the ribbed button on the upper round side of the tape 
> until
>   the tape is totally retracted and try the whole procedure again.
>   1. press the upper right key and a short beep will tell you that the
>   tape is ready for measuring
>   2. pull the tape end forward as far as required
>   3. press the upper right key again and the tape will announce the exact
>   length
>   Measurements with the case
>   Sometimes you will need to carry out measurements including the case of the
>   tape measure (e.g. within door-frames or inside closets), VOX-Tape offers
>   you the possibility to do so at the press of a button. Take a measurement
>   as mentioned above. If you want to know the value with the case, just press
>   the upper left button instead and the tape will announce the value measured
>   "with case”. If you want to hear the same measurement without case, 
> press
>   the upper right button (as you would at an ordinary measurement),
> 
>   Metric/Imperial system
>   With VOX-Tape you can take readings according to the metric or the imperial
>   system. Press the left key of the upper row for at least 2 seconds and you
>   can change between "metric system" and "imperial system".
> 
>   Retain current value/standard measurement
>   VOX-Tape enables you to retain a value independently from the standard
>   memory function. After the tape announces your measurement result, you can
>   retain this value by pressing the lower middle key. The tape announces
>   “current value retained”. Now you can retract the tape and 
> still recall
>   this last value by pressing the upper right key. To delete this value,
>   press the lower middle key again and you will hear the announcement
>   "current value released". Now you are able to carry out normal measurements
>   again.
> 
>   Reset to zero / standard measurement
>   After you have taken a measurement, press the lower middle key until you
>   hear the second beep sound. Release the key and VOX-Tape will announce
>   “reset to zero”. At your next measurement, the tape will only 
> announce the
>   difference between these two values. This function enables you to compare
>   different measurements more easily. To leave this function, press the lower
>   midd1e key until you hear the second "beep", release the key and the tape
>   will announce “standard measurement”.
> 
>   Memory
>   VOX-Tape also possesses a memory function. Measurements can be added to
>   memory to enable total measurements up to 37.3 miles (equals 60 km). Carry
>   out a measurement as described above. If you want to add this value to the
>   memory of the tape, press the lower right key and the tape will announce
>   “added to memory”.
> 
>   Recall memory
>   You can recall the content of the memory at the press of a button. Press
>   the lower left key and the tape will announce the total value in the memory
>   (“total value in memory is”). If so far no value has been added 
> to memory,
>   the tape will announce "memory clear".
> 
>   Delete memory
>   To delete all the values in the memory, hold the lower left key until you
>   hear the second beep sound. Release the key and the tape will announce
>   “memory deleted”.
> 
>   Technical data / Warranty
> 
>   |Dimensions |3 3/4 x 2 5/8 x 1 5/8 inches / 84 |
>   | |ounces incl. battery |
>   |Measuring units |metric and imperial system |
>   |Measuring accuracy |resolution of 1/16 inches |
>   |Measuring length |16 feet |
>   |Power supply |1 x AA Mignon Battery (1.5V) |
>   |Warranty |1 year on the speech output |
> 
>   CARETEC GmbH
>   Stubenbastei 1
>   A -1010 Wien, Osterreich
>   Tel: (+431) 5138081-0
>   Fax: (+431) 5138081-9
>   [EMAIL PROTECTED]
>   www.caretec.at
> 
> 
> 
>    
> 
> [Non-text portions of this message have been removed]
> 
> 

Reply via email to