Dan, could you give me the madel numger of that new router? Thanks, Tom
From: [email protected] [mailto:[email protected]] On Behalf Of Dan Rossi Sent: Thursday, June 18, 2009 10:43 AM To: [email protected] Subject: RE: [BlindHandyMan] New router: was new toy Bill, I have no idea if you could use any router, in general, to do metal work. I would think you might want more horsies under the hood than this little router, and probably a half inch shank, possibly with special bits. Depends on how much metal you want to hog out. I mean, a milling center is sort of like a router on steroids. Or more like if a drill press and router hooked up at a bar and .. well .. you know what I mean. -- Blue skies. Dan Rossi Carnegie Mellon University. E-Mail: [email protected] <mailto:dr25%40andrew.cmu.edu> Tel: (412) 268-9081 [Non-text portions of this message have been removed]
