Scott, I don't know what you mean by boosting the material. The bit is for trimming off any excess material.
earlier, Scott Howell, wrote: > > >Ah, okay, so what I gather is I'd have to boost the material up some >so the baring is cleared and the cutting edge will touch the material >and that makes sense. > >tnx, >On Aug 25, 2009, at 6:16 AM, john schwery wrote: > > > Scott, I don't know about speed, but you place the bit so the bearing > > is below where you want to cut, I would say, about a quarter inch > > below.I have used this bit a lot on wood and it works great. > > earlier, Scott Howell, wrote: > > > > > > > > >Folks, I have a question. > > > > > >I got a laminate router bit to trim some thin laminate material, > > which > > >will go on the unfinished end of a counter top. Now I tried using a > > >utility knife and all that, but this is a case where the router might > > >work a little better. Since the bit was pretty inexpensive, I'm more > > >interested in just trying this out since I could with a lot of > > >patience work at cutting and smoothing. In any case, there is a > > >baring at the bottom of the bit and then the cutting edge. How does > > >one effectively use this bit and at what speed would I want to trim > > >the material? > > > > > >tnx, > > > > > > > John > > > > [Non-text portions of this message have been removed] > > > > > > > >[Non-text portions of this message have been removed] > > John [Non-text portions of this message have been removed]
