yeah yeah, okay, thank you. Got it. So the most important part of the process is the exact depth set of the router, right?
On Sat, 29 Aug 2009, Bob Kennedy wrote: > The bit has a bearing at the end that is the exact same diameter as the > cutting parts of the bit. Think of a drill bit with the flutes running > vertically. The flutes would be the part that cuts. The bearing is beyond > the flutes and that rides on the top or front depending on what part you are > cutting. > ----- Original Message ----- > From: Spiro > To: [email protected] > Sent: Saturday, August 29, 2009 10:21 AM > Subject: Re: [BlindHandyMan] Using a laminate router bit > > > so what's it look like? > Is there a fame that holds the ball? It's sort of a portable fence device? > Sounds like an edging bit but I've never seen one? > > On Tue, 25 Aug 2009, Dan Rossi wrote: > >> Scott, >> >> Just so you are on the same page, I am pretty sure that the way you would >> normally use this bit is that the laminate is already attached to the >> substrate but it is cut a bit large. You then use the router with this >> bit to flush cut the laminate to the substrate. That is my understanding >> of it. >> >> -- >> Blue skies. >> Dan Rossi >> Carnegie Mellon University. >> E-Mail: [email protected] >> Tel: (412) 268-9081 >> > > > > > [Non-text portions of this message have been removed] > >
