Everything is positioned as you say. A lot of the time, I just press the button on the unit. Is it possible the cable is bad?
Loren ----- Original Message ----- From: Bob Kennedy To: blindhandyman@yahoogroups.com Sent: Saturday, July 31, 2010 2:04 PM Subject: Re: [BlindHandyMan] help with new talking multimeter I don't have that problem myself. Make sure both plugs are seated firmly and the probe with the button needs to be on the left hand side when laying on its back with the plugs at the top. ----- Original Message ----- From: Loren Buntemeyer To: blindhandyman@yahoogroups.com Sent: Saturday, July 31, 2010 9:47 AM Subject: Re: [BlindHandyMan] help with new talking multimeter I just came aboard to the list and I also have one of those meters and many times the unit does not talk when I press the button on the handpiece. Does anyone else have that problem? Loren Buntemeyer ----- Original Message ----- From: Bob Kennedy To: blindhandyman@yahoogroups.com Sent: Saturday, July 31, 2010 5:03 AM Subject: Re: [BlindHandyMan] help with new talking multimeter Here ya go. The batteries were in mine when I got it. To replace them, there is a Phillips head screw in a small recess on the back. Just a warning, the cover is very happy in place and it doesn't like opening up... But the batteries are under that cover. For orientation, lay the meter on its back with the jacks for the probes at the top. The probe with the button goes on the left side. Probes will fit on both sides but won't work if they get reversed. Below the two jacks for the probes is the selector dial. Turning the dial to the farthest stops in either direction will turn the meter off. To make a choice, turn the dial once and push the button on the probe. Depending on the direction you start from, the female voice will tell you where you are. She will say something like "AC .00 volts. Don't go by that as a direct quote, it's an example. Point being, each time you turn the dial and push the button, the voice will tell you the unit of measurement. I don't have mine in front of me so I won't be much help on the buttons below the dial. There is one on each side. One button will give you the reading just like pushing the button on the probe. I seem to remember the other selects different modes but I've been wrong before... Below those two buttons are three larger buttons across the face. Experiment with them and you'll be able to catch on to what they do. As long as you don't touch the probes to anything while you play, you won't hurt the meter. I seem to recall the one in the center is a toggle switch. For example touching the two probe tips together will test for continuity and cause the meter to make a sound while the probes are touching. If you push the center button once, the sound will start. Pushing it again will toggle sound off. The toggle has no effect on the speech, just the sound for continuity testing. This meter will test a ton of different functions some of which I have no use for, or even know what they mean. So maybe some other people can tell you about their uses. If you don't have a scanner, maybe I can scan in the instruction sheet. It isn't very long. They are assuming you already know the theory behind a multimeter. ----- Original Message ----- From: Peter Mikochik To: blindhandyman@yahoogroups.com Sent: Friday, July 30, 2010 2:37 PM Subject: [BlindHandyMan] help with new talking multimeter hi again just got the talking multimeter from marlin jones. can anyone tell me the basics like where do the batteries go? and wich side does the lead with the button go on? or anyother info about this. thanks for any help, can't wait to stick this in an outlet. [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]