kidstypike wrote: > The original drivers appear to be deeper than the 3FE25s and have a > further foam/rubber ring glued to the rear of the magnet housing, and > when assembled fit tight up against a reinforced moulding on the back of > the Booms cabinet, so the drivers/cabinet is braced front to back. The > replacement drivers are possibly just hanging off the front baffle. I > don't know if this is a good or bad point, just a heads up.
That's interesting. I was looking at photos of the dis-assembly of the Boom earlier tonight, and I noticed that little bit of foam on the back of the driver. I didn't realize that they actually sandwiched the whole thing between the rear of the enclosure and the front bezel. To be honest, I don't think the people designing this device had a fucking clue what they were doing when it comes to speaker design. They read spec sheets on drivers, they wrote software, they stuffed it all into a plastic box the way they figured it should work. ------------------------------------------------------------------------ JJZolx's Profile: http://forums.slimdevices.com/member.php?userid=10 View this thread: http://forums.slimdevices.com/showthread.php?t=105534 _______________________________________________ Boom mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/boom
